Experimental Research on Ultrasonic Vibration Deep Hole Honing of Titanium Alloy

Abstract:

Deep hole honing is the primary way of finishing, the main problems existing now are the low efficiency, high surface roughness, especially in the processing of difficult to cut materials. In this study, the test is on the titanium alloy and uses the self-developed ultrasonic vibration honing equipment. The results show that in the same conditions, the ultrasonic vibration in deep-hole honing can improve the efficiency about 1 times, and meanwhile the surface roughness can reach below 0.8μm, the oilstone is uneasy to block, and the technical effects are better than traditional honing process.

• Periodical: Advanced Materials Research (Volumes 314-316)
• Pages: 1107-1111
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.314-316.1107
• Online since: August 2011
• Authors: Hong Bing Zhao, Ying Fei Nan
• Keywords: Deep-Hole Honing, Honing, Ultrasonic Vibration

References

[1] L. ZHU: New Technology And New Process. Vol. 8 (2001), p.24.In Chinese.

[2] S.Q. Wang: Deep Hole Processing Technology. (Press of north-west polytechnic University, China 2003).

[3] Y. WU, B. ZHAO and X.S. ZHU: Manufacturing Technology And Machine Tool. Vol. 4 (2006), p.59.In Chinese.

[4] F.G. CAO and Q.J. ZHANG: Ultrasonic Machining Technology. (Press of Chemical industry, Beijing 2004).