An Improved Design of Controller for Medium Frequency Induction Power

Abstract:

Present a variety of advanced PID control algorithm in the use of induction heating power supply is increasingly broad, achieving good results in self-tuning of PID parameters. However, most of the output of PID control value is a single volume, such as DC power regulator for controlling the output voltage of rectifier or inverter power regulator for controlling the output frequency of inverter current. It has achieved a certain effect in the heat treatment process control, but did not take into account the actual efficiency of the power. The two adjustments will be combined in this article, using Smith prediction control algorithm and methods based on the Ziegler-Nichols PID tuning algorithm for time delay system. Both of the raising of induction power efficiency and lower system energy consumption has been achieved.

• Periodical: Advanced Materials Research (Volumes 383-390)
• Pages: 643-647
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.383-390.643
• Online since: November 2011
• Authors: Zheng Zhang, Xiao Wei Liu, Min Jiang, Guo Cheng Wan
• Keywords: Energy Conservation Improvements, Joint Regulation, Medium Frequency Induction Power, PID

References

[1] Su Zhongde, Zou Qin, Xi Jiaqing. Development of Now coreless medium frequency induction power for melting[J]. Mechanics, 2006. 12 (4).

[2] Wu Zhaolin, Lin Gang, Lan Kui. Series inverter of high frequency induction power for heating[J]. Technology of Power Electronics, 1994. 28 (1).

[3] Dai Yuhang. IGBT transistor module of medium frequency induction heating furnace [J]. Casting, 2000. 9.

[4] Luo Xiaoye. resonant frequency tracking of medium frequency induction heating device based on SOC[J]. Measurement and Control of Computer, 2007. 15 (10) Fig 3 Simulink system simulation program Fig. 4 Circuit simulation Figure 5 Step response of system Figure 6 Active and reactive power of grid side.