Preparation of Cu-Zn Alloy by Different High Energy Ball Milling

Kai Jun Wang; Xiao Lan Cai; Hua Wang; Jin Hu; Yun Feng Zhang

doi:10.4028/www.scientific.net/AMR.412.259

Paper Titles

Preparing Flake Silver Powder by High-Energy Ball Milling
p.243

Preparation of Micro-Sized Silver Powder Utilized in Paste for Solar Cell Grid Electrode
p.247

Preparation of Flake Silver Coated over Copper Powder
p.251

Preparation of Ultrafine Tungsten-Based Alloy Powders by GNP-Reduction Method
p.255

Preparation of Cu-Zn Alloy by Different High Energy Ball Milling
p.259

Preparation and Property of Al₈₇Ce₃Ni_8.5Mn_1.5 Nanophase Amorphous Composites
p.263

Dispersion Properties of Li_1.075Nb_0.625Ti_0.45O₃ Powders in Aqueous Media
p.267

A Calcination Technology for Ultrafine La₃NbO₇ Powder Prepared by Sol-Gel Process
p.271

Influence of Lanthanum on Microstructure and Dielectric Properties of Barium Titanate Ceramics by Solid State Reaction
p.275

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 412Preparation of Cu-Zn Alloy by Different High...

Preparation of Cu-Zn Alloy by Different High Energy Ball Milling

Abstract:

Cu-Zn alloy was prepared by high energy ball milling of elemental copper and zinc by the Simoloyer attrition mill, the different parameters such as milling time, ball-to-powder ratio and rotational speeds were analyzed. The results show that the different Cu-Zn alloy phase can be produced by different ball milling parameters, It has been found that milling time is highly significant to refining process, and the ratios of ball to powder are also benefited to the new phase form.