Study on the Machinability of Free-Cutting Steels 1214 and 12L15 with Coated Tool

Ying Ying Wei; Zhi Qiang Liu; Qing Long An; Ming Chen

doi:10.4028/www.scientific.net/AMR.426.151

Paper Titles

Research on the Nano-Hardness of Single Crystal Aluminum
p.135

Selection of Minimum Quantity Lubrication (MQL) Parameters in Milling of Ti-6Al-4V
p.139

Study on Machining Distortion of Residual Stress Release
p.143

Study on Micro-Deformation Behavior of Sicp/Al Composites at Low Stress
p.147

Study on the Machinability of Free-Cutting Steels 1214 and 12L15 with Coated Tool
p.151

Study on the Microstructure and Mechanical Properties of TiB2-Ti(C,N) Composite Ceramic Tool Materials
p.155

The Deformation Analysis on Tooth Profiles with Electroplated CBN Hard Gear-Honing-Tools
p.159

The Influence Analysis of Globular Indexing Cam Mechanism Size Parameters on Transmission Performance
p.163

The Influence of High-Speed Cutting Technics Parameter No Materials Removal in Turning High Alloy Antifriction Cast Iron
p.168

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 426Study on the Machinability of Free-Cutting Steels...

Study on the Machinability of Free-Cutting Steels 1214 and 12L15 with Coated Tool

Abstract:

Research has been done on machinability of two different kinds of free-cutting steels by using coated cutting tool at the condition of different cutting parameters. Orthogonal tests are adopted in order to compare the cutting performance of the two materials. The cutting force, surface roughness, chip morphology and tool wear are investigated, which reveal the influence of Pb and other composition on machinability. The experiment shows that 1215 has more or less better performance than 12L14. It is of great significance for the development of environmental friendly products.