The Representative Volumetric Parameter for Dense-Graded Asphalt Mixture

Abstract:

Volumetric parameters of asphalt mixture are essential for a better understanding of the properties of an asphalt mixture. This is even more applicable for a dense-graded asphalt mixture, where volumetric parameters have a significant correlation with its pavement performance, especially against rutting and moisture. This paper deals with the choice of the representative volumetric parameter for dense-graded asphalt mixture. A total of 6 volumetric parameters were studied. Volumetric analysis showed that linear correlation existed between any two of volumetric parameters. The change of volumetric parameters was mainly caused by the variation of gradation. The test result indicated that volumetric parameters were sensitive to the variation of gradation. The finding also indicated with the variation of gradation, the change rate of is the largest. Based on the research above, was selected as the representative volumetric parameter for dense-graded asphalt mixture.

• Periodical: Advanced Materials Research (Volumes 446-449)
• Pages: 3334-3340
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.446-449.3334
• Online since: January 2012
• Authors: Da Qing Wang, Yi Qiu Tan, Hui Ning Xu
• Keywords: Aggregate Gradation, Asphalt Mixture (AC), Volumetric Parameter

References

[1] WALTER P.HISLOP AND BRIAN J. COREE . "VMA as a Design Parameter in Hot-Mix Asphalt" .(2002)

[2] Qiu, Y.F., Lum, K.M..2006. Design and Performance of Stone Mastic Asphalt. JOURNAL OF TRANS-PORTATION ENGINEERING , 2006(12)

[3] Brian J. Coree, Ph.D, P.E. "The Difficult Nature of Minimum VMA: A Historical Perspective".(1998)

[4] Asphalt Institute. "Superpave Level Mix Design Superpave Series No2(SP-2)". Lexington.1995,8

[5] Vavrik W R ,Pine W J,Huber G A,et al. "The bailey method of gradation evaluation ：The influence of aggregate gradation and packing characteristics on voids in the mineral aggregate". Journal of the Association of Asphalt Paving Technologists,p.1~5,(2001)

DOI: 10.31274/rtd-180813-13953

[6] Lin Xiu-xian. "Discussion on Design Air Voids and Minimum Voids of Mineral Aggregate Requirements for HMA." Shanghai Highways,2004.

[7] AASHTO Designation："PP28-02 Standard Practice for Superpave Volumetric Mix Design"

[8] Li Li-han, Guo Ya-bing, Zheng Hang, Cao Lin-tao."Study on Relationship between Gradation and Volume Parameters of Asphalt Mixes." Journal of Building Materials, 2005.

[9] Jinzhi Xu,Peiwen Hao. "DESIGN OF SMA BASED ON THREE-LEVEL DISPERSEN SYSTEM". The Third CHINA-JAPAN Workshop on Pavement Techology

[10] Sun Hu. Applied mathematical statistics. TSINGHUA UNIVERSITY PRESS, (2006)