Based on the ANSYS of Small and Deep Hole a Bit Cutting Transient Dynamic Study

Ping Wei; Jiang Han; Hui Lian Geng

doi:10.4028/www.scientific.net/AMR.503-504.802

Paper Titles

The Analyze of Shear Force Calculation Model of Drum Type Linear Blade Flying Shear
p.785

Analysis of Influence to the Connect and Seal Ability of Tubing Connection of Inner Pressures
p.790

Structural Optimization of a Novel Coaxial Magnetic Gear
p.794

Numerical Simulation and Research of Far Infrared Sterilization Tunnel
p.798

Based on the ANSYS of Small and Deep Hole a Bit Cutting Transient Dynamic Study
p.802

The Dynamic Strength Analysis the Key Parts of Body of RG
p.805

Calculating Method about the Normal Clearance Magnitude of the Water Pump Shroud by the Boundary-Layers Theory
p.809

Vibration of a Misaligned Rotor System with Asymmetric Shaft Stiffness
p.813

Steel-Cylinder Yielding Analysis of PCCP with Broken Wires
p.819

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 503-504Based on the ANSYS of Small and Deep Hole a Bit...

Based on the ANSYS of Small and Deep Hole a Bit Cutting Transient Dynamic Study

Abstract:

Introduces the general twist drill analysis, Through the continuous experiment and practice, obtained some processing key question method. As a result of small and deep hole parts of the scene processing efficiency is low, the improper selection of cutting quantity will cause premature wear of cutting tool. The traditional method is the empirical method and experimental method to solve the waste of material and time comparison. This article mainly is the finite element analysis software, the analysis of the ordinary drill thermal stress, transient dynamics, to solve the optimization of cutting parameters before processing, improve processing efficiency, save cost.