Improvements of Superheated Steam Stimulation in Secondary Development of Heavy Oil Reservoir

Abstract:

With superheated steam, there is no direct relationship between temperature and pressure, Therefore, at a particular pressure it is possible for superheated steam to exist at a wide range of temperatures higher than that of its saturated steam. The heat transfer coefficient is 1/150-1/250 as much as that of saturated steam during heat transferring, and it takes a relatively long time to cool, during which time the steam is releasing very little energy and transmitted long distances. The mechanisms of superheated steam stimulation are mainly pointed to the performance of crude oil viscosity reduced, flow environment improved, rock wettability changed, oil displacement efficiency improved. Physical simulation shows that oil displacement efficiency by superheated steam is 6-12% higher than that of saturated steam at the same temperature, and under the condition of carrying the same heat, superheated steam enlarged the heating radius by about 10m, oil steam ratio increased by 0.7. Superheated steam stimulation was put into Kazakstan’s heavy oil reservoir after two cycles of saturated steam stimulation. The average daily oil production was 2-4 times that of saturated steam stimulation, which improved heavy oil production effectively. The secondary heavy oil thermal recovery by superheated steam stimulation applied in marginal heavy oil reservoirs achieved satisfactory effect.

• Periodical: Advanced Materials Research (Volumes 524-527)
• Pages: 1450-1455
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.524-527.1450
• Online since: May 2012
• Authors: An Zhu Xu, Xiang Hong Wu, Zi Fei Fan, Lun Zhao, Cheng Gang Wang
• Keywords: Heat Transfer Coefficient (HTC), Heavy Oil, Recovery Mechanism, Secondary Thermal Recovery, Superheated Steam Stimulation

References

[1] Yitang Zhang, Xiuluan Li, Xia Zhang, et al. "Four fundamental principles for design and follow-up of steam flooding in heavy oil reservoirs"[J]. Petroleum Exploration and Development, 2008, 35(6): 715-719.

[2] Xianghong Wu, Anzhu Xu, Hailiang Fan "An integrated evaluation on factors affecting the performance of superheated steam huff and puff in heavy oil reservoirs"[J]. Petroleum Exploration and Development, 2010, 37(5):608-613.

DOI: 10.1016/s1876-3804(10)60059-6

[3] Tongci Qu, Shuang Li. "Technique of enhancing recovery of remaining oil in heavy oil reservoirs by horizontal wells"[J]. Petroleum Exploration and Development, 2009, 36(6): 743-748.

[4] Ke Yan, Huaiqiang Ren. "Oil/water inversion and juxtaposition in heavy oil reservoirs": Taking 6-7 sand members of Guantao Formation, Gudao Oilfield as an example[J]. Petroleum Exploration and Development, 2009, 36(5): 635-640.

[5] Heins B, Xiao Xie, Dengchao Yan. "New technology for heavy oil exploitation wastewater reused as boiler feedwater"[J]. Petroleum Exploration and Development, 2008, 35(1): 113-117.

DOI: 10.1016/s1876-3804(08)60016-6

[6] Yuwen Chang, Yi Zhang, Yongjiu Hu, et al. "The progress of heavy oil thermal recovery technology"[M]. Beijing: Petroleum Industry Press, 1997.

[7] The International Association for the Properties of Water and Steam.IAPWS-IF97 International Formulation 1997 for the Thermodynamic Properties of Water and Steam [R].Erlangen, Germany, 1997.

DOI: 10.1007/978-3-662-53219-5_3

[8] Rohsenow, Warren M, et al. "Application of Heat Transfer Handbook"[M]/Book1. Beijing: Science Press, 1992.102-135.

[9] Weidao Shen, Zhimin Jiang, Jungeng Tong. "Engineering thermodynamics" [M]. Beijing: Higher Education Press, 2000. 212-229.

[10] Chuntao Li, Genbao Qian, Shuhong Wu, et al. "The property of superheated steam and its application in the development of heavy oil reservoirs: Kenkiyak Oil Field in Kazakhstan as an example"[J]. Xinjiang Petroleum Geology, 2008, 29(4): 495-497.