Effects of Non-Electrical Parameters on Material Removal Rate of High-Speed Small Hole EDM Drilling

Ming Rang Cao; Y.Q. Wang; Shi Chun Yang; Sheng Qiang Yang; Wen Hui Li

doi:10.4028/www.scientific.net/AMR.53-54.403

Paper Titles

Temperature Dependence and Effect on Surface Roughness in Abrasive Flow Machining
p.375

Research on Small Dimension Precision Turning Technology for Internal Spherical Surface
p.381

Dry WEDM in Improving LS-WEDMed Surface Quality
p.387

A Study on Abrasion-Assisted Electrodeposition of Bright Nickel
p.393

Optimization of Cutting Force by Exponential Model in Milling Heat-Resistant Steel F91
p.397

Effects of Non-Electrical Parameters on Material Removal Rate of High-Speed Small Hole EDM Drilling
p.403

Numerical Simulation of Liquid-Solid Two-Phase Flow Field in Discharge Gap of High-Speed Small Hole EDM Drilling
p.409

FEM Analysis and Experimental Study on Residual Stress Induced by Form-Milling and Rolling of Rotor Steel 26NiCrMoV145
p.415

Parameter Selection Rules for Error Separation by Multi-Probe Method
p.421

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 53-54Effects of Non-Electrical Parameters on Material...

Effects of Non-Electrical Parameters on Material Removal Rate of High-Speed Small Hole EDM Drilling

Abstract:

The selection of manufacturing conditions is very important in manufacturing processes as these ones determine the material removal rate (MRR) of the so-obtained parts. So in this paper, based on the brief introduction of the experimental principle and the high-speed small hole EDM drilling system, effects of non-electrical parameters on MRR are discussed in detail. The relationships between MRR and these factors are also analyzed. The conclusion can provide an important reference for production in practice.