Liquid-Phase Selective Hydrogenation of Nitrobenzene over Ultrasonic-Assisted Ni-Mo-P Amorphous Catalyst

Qian Wen Dai; Zi Li Liu; Cui Xia Xu; Qi Gang Xie; Fan Zhang; Jian Jie Zhang

doi:10.4028/www.scientific.net/AMR.550-553.420

Paper Titles

Synthesis of Benzaldehyde 1, 2-Propanediol Acetal by Using Ionic Liquid [Hmim]HSO₄ as Catalyst
p.400

Preparation and Photocatalytic Activity of Bi Doped TiO₂ with Visible-Light Response
p.404

Research on Catalytic Combustion of Low Concentration Methane in Combustion Channel of Compact Reformer
p.411

Reaction Characteristic of MeAPSO-34 (Me=Mn, Co) Catalysts for Olefins Production from Dimethyl Ether
p.416

Liquid-Phase Selective Hydrogenation of Nitrobenzene over Ultrasonic-Assisted Ni-Mo-P Amorphous Catalyst
p.420

Preparation of MgAlY-LDO Solid Base Catalysts and their Catalytic Performance on the Synthesis of Isophorone via Acetone Condensation
p.424

The Effect of Oxygen on Bunsen Reaction with HI_X Solution in Sulfur-Iodine Hydrogen Production Process
p.431

Variation in the Volume Ratio of HI_X Phase/H₂SO₄ Phase for Improvement of Phase Separation Efficiency in the Bunsen Reaction Section
p.435

Research on the Structure of Cylindrical Proton Exchange Membrane Fuel Cell Based on ANSYS
p.439

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 550-553Liquid-Phase Selective Hydrogenation of...

Liquid-Phase Selective Hydrogenation of Nitrobenzene over Ultrasonic-Assisted Ni-Mo-P Amorphous Catalyst

Abstract:

The Ni-Mo-P amorphous catalysts were prepared by chemical reduction method under different sonication conditions. The catalytic performance of the prepared catalysts in selective hydrogenation of nitrobenzene(NB) to aniline(AN) were characterized by XRD, BET, N₂-adsorption, H₂-TPR and H₂-TPD. The results show that the introduction of ultrasonic can improve the dispersion of the active sites in the catalyst, the particle size of the catalyst is also smaller than the regular prepared Ni-Mo-P amorphous catalyst. And the influences of the sonication power and time on the catalysts were discussed and compared. The optimal sonication condition is 70 W within 25 min, its optimal reaction time is 150 min.