Improvement on the Technique for Production of Alkaline Battery Seal Ring

Abstract:

Through studying technology of the seal ring production of alkaline storage battery, some products were often found to have defects, such as product short shot, yellow and transparence was not good. According to the to identify the causes of the defects, in order to find ways to solve these problems, production processes were reasonably optimized .Under the seal ring of the injection molding process, raw material preparation, injection molding and post-processing work pieces in three stages, combined with the affecting factors in producing the ring. From the key factor that choose and control of the processing condition of the molding material, molding equipment, injection molding process in the appropriate temperature, pressure, velocity and time conditions, to find performance parameters of producing high quality seal, giving countermeasures to defects emerged in the production of alkaline batteries seal ring.

• Periodical: Advanced Materials Research (Volumes 550-553)
• Pages: 464-467
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.550-553.464
• Online since: July 2012
• Authors: Jia Min Zhang, Yuewen Li, Wen Qing Zhao
• Keywords: Alkaline Storage Batteries, Injection Molding, Seal Ring

References

[1] Xingtian Wang. Injection Molding Technology (China Chemical Industry press, Beijing 1989),in Chinese.

[2] Junqiu Yang. Engineering Plastics Application. Vol.33(7) (2005), p.23–25.in Chinese.

[3] Jianxiong Li, Shizhou Qiu. Chinese Battery Industry. Vol.7(3) (2002), p.200–202.in Chinese.

[4] Kunlu Zhou, Jianzhu Liu.Engineering Plastics Application. Vol.31(1) (2003), p.31–34.in Chinese.

[5] Zhengwei Gu, Peifu Fu. Synthetic resin and Plastics. Vol.18(5) (2001), p.57–60.in Chinese.

[6] Yingsheng Ma, Yansheng Zheng. Aerospace Manufacturing Technology. Vol.(6) (2001), p.45–47.in Chinese.