Development of Al2O3/TiCN Ceramic Composite Cutting Tool and Research on its Milling Performance

Ping Zou; Xu Lei Yang; Cong Yun Li; Wen Yuan Tian; Li Jie Chen

doi:10.4028/www.scientific.net/AMR.565.460

Paper Titles

Study on the Combined Machining Technology of Sawing and Grinding for Drilling Aramid/Epoxy Composites
p.436

Investigation of Micro-Drilling for Printed Circuit Boards Containing High-Hardness Fillers
p.442

Modeling the Property Variation of Diamond Composite and its Impact on the Reliability of Cutting Tools
p.448

Cutting Forces and Tool Wear in Dry Milling of Ti6Al4V
p.454

Development of Al₂O₃/TiCN Ceramic Composite Cutting Tool and Research on its Milling Performance
p.460

Ball-End Milling of Cr12MoV Die Steel Using Ceramic Tool and Cements Carbide Tool
p.466

An End-Milling Condition Decision Support System Using Data-Mining for Difficult-to-Cut Materials
p.472

Research on the Drilling Temperature Field Model of the Unidirectional Carbon Fiber Epoxy Composites
p.478

Chip Formation Characteristics in High-Speed Machining of Hardened AISI1045 Steel
p.484

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 565Development of Al2O3/TiCN Ceramic Composite...

Development of Al₂O₃/TiCN Ceramic Composite Cutting Tool and Research on its Milling Performance

Abstract:

In this paper, ceramic composite materials for the milling tools have been developed by the hot pressing method. High performance Al2O3/TiCN ceramic composite materials were obtained successfully by adjusting the containing amount of Al2O3 and TiCN as the base material and the reinforcements in the ceramic composite materials, and optimizing the sintering process parameters. Moreover, the microstructure and mechanical property of this material was discussed. In addition, this new developed ceramic composite material was made into insert and its milling performance tests were carried out. The machining performance of the insert is better than carbide inserts when milling a hardened carbon steel.