High Speed Machining of AISI 52100 Steel

Ya Jun Liu; Jia Bin Huang; Meng Yang Qin; Wei Xia; Yong Tang

doi:10.4028/www.scientific.net/AMR.69-70.466

Paper Titles

Research on the Adaptive Machining Technology of Blisk
p.446

Experimental Study on High Speed Machining of a Titanium Alloy
p.451

Structural Design Method of High Speed Face Milling Cutter Based on Theory of Axiomatic Design
p.456

Real-Time NURBS Interpolator with an Optimal Feed for High-Speed Machining
p.461

High Speed Machining of AISI 52100 Steel
p.466

Surface Topography and Roughness Simulations for 5-Axis Ball-End Milling
p.471

Numerical Simulation of Adiabatic Shear Behavior in High-Speed Machining of Hardened Steel GCr15
p.476

An Investigation of Heat Dissipation in High Speed Machining
p.480

Machinability and Tool Wear Behavior in Turning High Nickel-Base Alloy-G3
p.485

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 69-70High Speed Machining of AISI 52100 Steel

High Speed Machining of AISI 52100 Steel

Abstract:

This paper gives the details of High Speed Milling experiments with AISI 52100 steel (HRC52) by using coated carbide end mills. Cutting force and Surface roughness data are presented. The effects of cutting speeds (1000-8000rpm), widths of cut (0.05-0.4mm) and cutting conditions (dry cutting and dry cutting with air coolant) are investigated. The results show that in high speed milling of hardened steels, when cutting speed surpasses a critical value, cutting forces decrease as cutting speed increasing; and the increasing of widths of cut causes the increase of cutting forces approximately linearly; surface roughness does not experience obvious increase or decrease and has a minimum in a specific condition; the machining results of dry cutting with air.