Recognition of Noise Source on Tandem Vibratory Roller

Abstract:

Original noise of tandem vibratory roller is measured in according to national standard. Using surface noise intensity measurement, noise intensity has been analyzed in including before , after, left and right sides on the roller, left and right sides on the engine and the cab floor. Under the conditions between vibration and no vibration, noise distribution principle is similar and noise source of whole roller concentrated in the position installed engine. Noise source and engine components frequency characteristics have been obtained based on spectrum analysis. The major noise source on the left 7.5m is engine combustion noise, following by exhaust fan noise; the major noise source on the right 7.5m is exhaust fan noise, following by engine combustion noise; leak noise of cab floor is fan and engine combustion noise, meanwhile middle-high frequency noise impact greatly on interior of cab; exhaust noise belonging to broadband noise concentrates in lower frequency and middle-high frequency.

• Periodical: Advanced Materials Research (Volumes 694-697)
• Pages: 439-443
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.694-697.439
• Online since: May 2013
• Authors: Li Min Li, Zhong Xu Feng, Li Ping Zhao
• Keywords: Noise Intensity, Noise Pressure, Noise Source, Recognition, Spectrum, Vibratory Roller

References

[1] Zhong Chun-bin, Feng Zhong-xu, in: Vibration noise test and comprehensive performance evaluation of vibratory roller , edtied by Journal of Chang ' an University,2007.5, 27(3).

[2] Zhang Zhi-feng, Feng Zhong-xu, in: Vibration influence of vibratory roller on building and control countermeasures, edtied by Journal of Chang ' an University,2007.1, 27(1).

[3] GB/T8511-2005,in: Vibratory roller, edtied by Beijing: Standards Press of China,2005.

[4] GB 16710.1-1996,in: Noise limits of engineering machinery, edtied by Beijing: Standards Press of China,1996.

[5] GB/T13802-1992,in: Radiation noise measurement general method of engineering machinery, edtied by Beijing: Standards Press of China,1992.

[6] GB/T 16710.2-1996, Outside radiation noise measurement of engineering machinery under the condition of stationary test, edtied by Beijing: Standards Press of China,1996.

[7] GB/T 16710.3-1996, Noise measurement around the driver place under the condition of stationary test, edtied by Beijing: Standards Press of China,1996.

[8] Wu Yan-bo, Yan Wen-bing, Fan Wen-xin, in: Noise intensity measurement of diesel engine surface and the identification of noise source, edtied by Mechanical Research & Application,2007, 27(1).