Measurement and Evaluation of Ferrite Materials Surface Quality

Wen Long Liu; Bin Lin; Li Peng Sun

doi:10.4028/www.scientific.net/AMR.721.130

Paper Titles

Quenching Effect on the Dielectric Properties of PVDF/ZnO Composites
p.113

A Pre-Stitching Method to Manufacture Z-Pins Reinforced Woven Ceramic Matrix Composite Laminates
p.117

Dielectric Response of Structured Multilayered Polyvinylidene Fluoride Films
p.121

Effect of Heat Treatment on the Properties of PB-1/PP Blends
p.125

Measurement and Evaluation of Ferrite Materials Surface Quality
p.130

A Simulation Analysis Research on the Material Performance of Resin Concrete
p.135

Comparative Study on Preparation of Al₂O₃-ZrO₂ Composite Powders by the Complexing Precipitate and Carbonblack Coating Methods
p.139

Study on Photo-Degradation of Poly(ethylene terephthalate)/SiO₂/TiO₂ Hybrid Composites by Sol-Gel Method under Ultraviolet Radiation
p.144

On the Time Dependency of the Chloride Diffusion in High Performance Concrete
p.148

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 721Measurement and Evaluation of Ferrite Materials...

Measurement and Evaluation of Ferrite Materials Surface Quality

Abstract:

A measurement on the topography and 3D roughness parameters of the ferrite surface has been taken by using a 3D optical profiler. Based on the analysis of the experimental data and the contradistinction between the ferrite devices with different quality and service performance, one preliminary conclusion has been obtained that the surface quality of ferrite materials can be evaluated by using the 3D roughness parameters, and this method is applicable and stable. With qualitative and quantitative analysis, it could be predicted that the surface quality has a direct influence on the service performance of ferrite devices.