Study on Mechanical Automation with Noise Characteristic and Control of Blower Room

Abstract:

The noise of blower room severity exceeds national standards,which affects normal performance of the new pharmaceutical factory,so it is necessary us to control noise. Based on the measured dates of blowers room, it carries out a noise source analysis and a discus of its noise characteristic in this article, then a controlling approach has found from absorbing noise, excluding noise to blockade sound transmission. When the controlling approach could not meet expect, a supplement program will be designed that vibration isolators will be installed under the basement of electric engine and blower, flexible metal tubes will be installed to isolate vibration spread path. After a set utility controlling approach is implemented, the consequence shows that program not only gains good effects but also caters to more advanced criterion of manufacturers demand.

• Periodical: Advanced Materials Research (Volume 738)
• Pages: 191-194
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.738.191
• Online since: August 2013
• Authors: Huan Liu, Han Cui
• Keywords: Blower, Control, Noise Characteristic, Noise Isolation, Vibration Isolator

References

[1] R I. Daubechies. Ten Lectures on Wavelets. Pennsylvania: SIAM(1992).

[2] G. Henkelman, G. Johannesson and H. Jónsson, in: Theoretical Methods in Condencsed Phase Chemistry, edited by S.D. Schwartz, volume 5 of Progress in Theoretical Chemistry and Physics, chapter, 10, Kluwer Academic Publishers (2000).

[3] R.J. Ong, J.T. Dawley and P.G. Clem: submitted to Journal of Materials Research (2003).

[4] P.G. Clem, M. Rodriguez, J.A. Voigt and C.S. Ashley, U.S. Patent 6, 231, 666. (2001).

[5] Chinmaya Kar, A.R. Mohanty. Application of KS test in ball bearing fault diagnosis. Journal of Sound and Vibration , 269 (2004), p.439.

DOI: 10.1016/s0022-460x(03)00380-8

[6] Y. F. Wang, AND P. J. Kootsookos. Modeling of Low Shaft Speed Bearing Fault for Condition Monitoring. Mechanical Systems and Signal Processing , , 42(1998), p.415.

DOI: 10.1006/mssp.1997.0149

[7] C. K. Mechefske, J. Mathew. Fault Detection and Diagnosis in Low Speed Rolling Element Bearings Using Inductive Inference Classification. Mechanical Systems and Signal Processing, 9(1995), p.275.

DOI: 10.1006/mssp.1995.0023

[8] Chen Changzheng, Sun Changcheng . Fault Diagnosis for Large-scale Wind Turbine Rolling Bearing Using Stress Wave and Wavelet Analysis. ICEMS(2005), p.878.

DOI: 10.1109/icems.2005.202966

[9] Dj.M. Maric, P.F. Meier and S.K. Estreicher: Mater. Sci. Forum Vol. 83-87 (1992), p.119.