Effect of Ni on the Properties of a Laser Surface-Clad Fe-Based Alloy

Xiu Ying Yang

doi:10.4028/www.scientific.net/AMR.750-752.2035

Paper Titles

Corrosion Protection of Molybdenum-Phosphorus Compounds Based Coating Formed on Hot Dip Galvanized Steel in a Cl^- Ione Environment
p.2017

Fabrication of Magnetic Cenosphere Deposited with Fe₃O₄ Nanoparticles by Hydrothermal Method
p.2021

Hyper-Dispersant Modifier Prepared and Applied in Polyethylene Composites
p.2026

Dynamic Simulation of Heating Situation of Spraying Powder
p.2031

Effect of Ni on the Properties of a Laser Surface-Clad Fe-Based Alloy
p.2035

Effect of Calendering Conditions on the Properties of Paper
p.2040

Coating Nano-Nickel Film on Cenospheres by Magnetic Sputtering Method
p.2044

Effects of Vanadium on Microstructure and Properties of a Fe-Cr-W-Mo-V Overlaying Alloy
p.2048

The Effect of Different CeO₂ Addition on Performance of Ni-WC Composite Coating by Vacuum Fusion Sintering
p.2052

HomeAdvanced Materials ResearchAdvanced Materials Research Vols. 750-752Effect of Ni on the Properties of a Laser...

Effect of Ni on the Properties of a Laser Surface-Clad Fe-Based Alloy

Abstract:

Two Fe-based alloys , Fe-15Cr-5Ni and Fe-16Cr-7Ni (wt. %), with a small variation in the Ni content were fabricated on a martensitic stainless steel 1Cr13 substrate by laser surface cladding (LSC) using a CO2 laser and Ar shielding gas that was blown into a moten pool. Both LSC alloys exhibited typical rapid directional solidification structures. However, 2 wt% Ni increase led to ~9% increase in the weight fraction of austenite, and ~5% increase in the area proportion of interdendritic regions which contained the higher Cr contents. These microstructural changes caused a great reduction in the microhardness and great improvements in the resistance to electrochemical corrosion in 0.5M H2SO4 solution. The reasons for these differences are discussed in detail.