Degradation of Organophosphorus Pesticide in a Packed-Bed Plasma Reactor: Effects of Operating Parameters and Kinetics Study

Abstract:

The degradation effectiveness and reaction kinetics of representative organophosphorus (OP) pesticide in a packed-bed plasma reactor have been studied. Important parameters, including peak voltage, pulse frequency, gas-flow rate, initial concentration, diameter of catalyst particles, and thickness of catalyst bed which influences the removal efficiency, were investigated. Experimental results indicated that rogor removal efficiency as high as 80% can be achieved at 35 kV with the gas flow rate of 800 mL/min and initial concentration of 11.2 mg/m^3. The removal efficiency increased with the increase of pulsed high voltage, and pulse frequency, the decrease of the diameter of catalyst particles and the thickness of catalyst bed. Finally, a model was established to predict the degradation of the rogor, which generally can simulate the experimental measurements to some degree.

• Periodical: Advanced Materials Research (Volumes 781-784)
• Pages: 1637-1645
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.781-784.1637
• Online since: September 2013
• Authors: Ting Jun Ma, Yi Qing Xu
• Keywords: Kinetic Model, Plasma-Catalyst, Rogor Decomposition

References

[1] Munnecke,I. H: Applied and environmental microbio1ogy Vol. 68(2002),P. 3371- 3376.

[2] A.K. Tayal, D. Linika, K. Inderjeet: Biomed. Chromatogr Vol. 13 (1999),P. 220–228.

[3] L.Z. Zhu, B.L. Chen, S. Tao: Environ. Sci. Technol Vol. 37 (2003), P . 4001–4006.

[4] Ghaly M.Y. Hartel,G. Mayer, R: Waste Management Vol. 21(2001),P. 41- 47.

[5] Ziegmann,M. Doll,T. Frimmel, H,F. Acta hydrochemicaet hydrobiologica Vol. 34(2006),P. 146-154.

[6] S. Delagrange, L. Pinard, J. M: Appl. Catal. B: Environ Vol. 68 (2006),P. 92–98.

[7] Urashima K. Kim,S. J . Chang , J .S.J. Adv. Journal of Advanced Oxidation Technologies Vol. 6(2003),P. 123-131.

[8] Urashima,K. Chang J. S: IEEE Trans. Dielectr. Electr. Insul Vol. 7(2001),P. 602-614.

[9] Chang,M. B, Chang,J. S: Ind. Eng. Chem. Res Vol. 45(2006),P. 4101–4109.

[10] W. Mista , R. Kacprzyk: Catalysis Today Vol. 137 (2008) ,P. 345.

[11] Hyun H.K. Atsushi,O. Shigeru, F: IEEE Transaction on Plasma Science Vol. 34(2006),P. 984-995.

[12] Guo Y.F. Ye,D.Q. Chen,K. F: Journal of Environmental Sciences Vol. 18(2006),P. 276-280.

[13] Francke K.P. Miessner,H. Rudolph,R. Catalysis Today Vol. 59(2000),P. 411-416.

DOI: 10.1016/s0920-5861(00)00306-0

[14] T. Oda: Journal of Electrostatics Vol. 57(2003),P. 293-311.

[15] Holzer,F. Roland,U. Kopinke,F. D: Applied Catalysis B: Environmental Vol. 38(2002),P. 163-181.

[16] Roland,F. Holzer F.D. Kopinke: Appl. Catal. B: Environ Vol. 58(2005),P. 217-226.

[17] Roland,U. F. Holzer, F.D. Kopinke. Appl. Catal. B: Environ Vol. 58 (2005),P. 227-234.

[18] Kim Y.H. Hong,S. H: IEEE Transactions On Plasma Science Vol. 30(2002),P. 168-169.

[19] Shim,J. H, Choi,S. K: IEEE Trans. On Magnetics Vol. 38(2002),P. 1181-1184.

[20] A.D. Koutsospyros : IEEE Trans. Ind. Applicat Vol. 33(2005),P. 42-49.

[21] Wakao,N. Kaguei, S: Heat and mass transfer in packed beds(Goron and breach science publishers, inc. 1982).

[22] Stefan Schmid. Matthias C. Jecklin, Renato Zenobi: Chemosphere Vol. 79 (2010),P. 124–130.

[23] Jim Van Durme. Jo Dewulf . Christophe Leys: Applied Catalysis B: Environmental Vol. 78 (2008),P. 324–333.

[24] E.R.G. Eckert, R.M. Drake: Analysis of heat and mass transfer. McGraw Hill, New York , （ 1972）.