Numerical Simulation of Deep Drawing Process of Drawing Cylinder Based on Dynaform

Abstract:

In addition to the high cost and long period, the traditional design of the drawing process depends too much on empirical formulas and data. To solve this problem, the paper proposes an ideal design process of the drawing process, which improves the traditional design process bases on CAE and applies FEM software Dynaform. The paper takes a drawing cylinder as an example, which needed 4-stage drawing process, could be improved into 3-stage by the simulation analysis of CAE, as a result , which can reduce the cost and improve the production efficiency.

• Periodical: Advanced Materials Research (Volumes 816-817)
• Pages: 294-297
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.816-817.294
• Online since: September 2013
• Authors: Sheng Wei Yang
• Keywords: Drawing Process, Numerical Simulation, Progressive Die

References

[1] Guo Cheng ChuGuYou. Modern stamping technology handbook. Beijing: standards press of China. (2010).

[2] Bob Carabbio. Methods and Application of In-Die Dimensional Measureme nt Metal Forming, Jan, (2009).

[3] Michael R. Duffeyet. al. Knowledge-Based Design of Progreessive Stamping Dies. Journal of Material Processing Technology, (2011).

[4] Seal YanFeng, xinan. Party the sheet metal forming numerical simulation technology based on Dynaform 5. 7 . Light industry machinery, (2007).

[5] Li Shuoben. Stamping process mould learning. Machinery industry press, (2008).