Microstructural Evolution during Partial Remelting of 6061 Aluminum Bulk Alloy Prepared by Cold-Pressing of Alloy Powder

Yu Shi Chen; Ti Jun Chen; Wei Fu; Pu Bo Li

doi:10.4028/www.scientific.net/AMR.820.20

Paper Titles

A PbS Film Synthesized by Ultrasonic Wave Assisted Chemical Bath Deposition Method and its Application in Photoelectrochemical Cell
p.3

Design and Characterization of PbS/CdS Based Photovoltaic Cell
p.7

Shape Controllable Preparation of PbS Crystal by a Simple Solvothermal Method
p.11

Influence of Heat Treatment on the Microstructure and Properties of 7Cr17Mo Martensitic Stainless Steel
p.15

Microstructural Evolution during Partial Remelting of 6061 Aluminum Bulk Alloy Prepared by Cold-Pressing of Alloy Powder
p.20

Research on Sintering Polytechnic of PTFE/Al Reactive Materials
p.25

The Influences of Alternating Magnetic Field to the Microstructure and Mechanical Property of Diamond Agglomerations
p.30

Research of Aluminum Silicon Composite Layer on Heat Resistant Steel Grate by Cast-Infiltration Method
p.34

The Research of Anti-Counterfeiting Labels Based on Reflected Light Interference Color of Glass Beads
p.38

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 820Microstructural Evolution during Partial Remelting...

Microstructural Evolution during Partial Remelting of 6061 Aluminum Bulk Alloy Prepared by Cold-Pressing of Alloy Powder

Abstract:

The microstructural evolution was investigated during partial remelting of 6061 aluminum bulk alloy prepared by cold-pressing of atomized alloy powders. Meanwhile, the effect of heating temperature on semisolid microstructure was also studied. It was found that after partial remelted, a semisolid microstructure with small and nearly spherical particles can be obtained. The microstructural evolution can be divided into three stages: the rapid coarsening of grains and powders, the structure separation and spheroidization of powders, and the final coarsening behavior of primary particles. For most of the primary particles (larger than 10 μm) in the semisolid state, one particle originates from one original powder in the cold-pressed bulk alloy. Furthermore, proper elevated the heating temperature is beneficial to obtain ideal semisolid microstructure.