The Design of Mechanical System for Harbor Basin Wave Maker

Abstract:

The design of mechanical system for harbor basin wave maker is introduced in this article. The installation form of wave maker is ground to pin type. The push-wave plate is driven by the AC servo motor and ball screw. The parameters of ball screw and the selection of servo motor are determined by calculating, and then check the bearing capacity of servo motor. The performance test has verified that the design of wave-maker system can meet the requirements.

• Periodical: Advanced Materials Research (Volumes 97-101)
• Pages: 4420-4424
• DOI: https://doi.org/10.4028/www.scientific.net/AMR.97-101.4420
• Online since: March 2010
• Authors: Shou Jun Wang, Liang Liang Luan, Rong Sheng Song, Jun Yi Li
• Keywords: Ball Screw, Harbor Basin, Servo Motor, Wave Maker

References

[1] Zhang Yaqun: Control and its Realization of Wave Maker, Wuhan University of Technology, 2007. In Chinese.

[2] Liu Yueqin, Yin Shangxin: Journal of South China University of Technology, Vol. 28 (2000), pp.105-109. In Chinese.

[3] Zhang Ruibo, Wang Shoujun: Research on Wave Simulating Equipment for Harbor Engineering, 2008. In Chinese.

[4] Jiang Niandong, Digital Servo Control System and its Emulation for Absorbing Wave Maker, Guangzhou Institute of Energy Conversion, Chinese Academy of Sciences, 1992. In Chinese.

[5] Tomotsuka Yakayama, Tetsuya Hiraishi: Reproducibility of directional random waves in laboratory wave simulation, Report of the Poet and harbour Research Institute in Japan, (1989).

[6] Rao Zhengang, Wang Yongwei: Ball Screws and its Self-lock Device, Beijing: National Defence Industrial Press. In Chinese.

[7] Dai Shu: Metal Cutting Machine, Beijing: China Machine Press, 1997. In Chinese.

[8] Li Hong: Practical Handbook of Machine Design, Liaoning Science and Technology Press, 1999. In Chinese.