Optimal Design about Parameters of Cooling Pipes in Hot Stamping Die

Long Chen; Wei Chen; Jian Dong Li; Si Ning Heng; Jia Wu

doi:10.4028/www.scientific.net/AMR.988.263

Paper Titles

Arc Behavior of Dry Hyperbaric Gas Metal Arc Welding
p.245

Characteristic of Interface Crack Propagation in Dissimilar Weld Joints
p.249

Effect of Milling Parameters on Surface Roughness for High-Speed Milling of Pre-Sintering Zirconia
p.253

FEM Analysis of Profile Control Capability during Rolling in a 6-High CVC Cold Rolling Mill
p.257

Optimal Design about Parameters of Cooling Pipes in Hot Stamping Die
p.263

Prospect of Thin-Walled Adjusted Pressure Casting Process for Superalloys
p.268

Study on Controlling Lost Circulation of Pilot Hole in Raise Boring by Using Fuzzy Ball Drilling Fluid
p.274

The Rapid Measurement and Reconstruction Research on the Blades in the Grinding Process
p.281

Research on Selective Grinding of Yunnan Low-Grade Phosphate Rock
p.286

HomeAdvanced Materials ResearchAdvanced Materials Research Vol. 988Optimal Design about Parameters of Cooling Pipes...

Optimal Design about Parameters of Cooling Pipes in Hot Stamping Die

Abstract:

The design reasonability of cooling pipe greatly affects the quenching performance of hot stamping die. In this paper, rectangular box is the carrier, the parameters of cooling pipe section, such as the diameter of cooling pipe, the distance between cooling pipes, the distance between cooling pipes and die surface, were studied by numerical simulation and orthogonal experiments. The quenching uniformity was taken as the evaluation criterion during research. Finally, the optimal parameters about cooling pipes distributed in hot stamping die were obtained and the quenching uniformity was improved.

You might also be interested in these eBooks

Material, Mechanical and Manufacturing Engineering II

View Preview

Info:

Periodical:

Advanced Materials Research (Volume 988)

Pages:

263-267

DOI:

https://doi.org/10.4028/www.scientific.net/AMR.988.263

Citation:

Cite this paper

Online since:

July 2014

Authors:

Long Chen*, Wei Chen, Jian Dong Li, Si Ning Heng, Jia Wu

Keywords:

Cooling Pipe, Hot Stamping, Parameters Design, Quenching Uniformity

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

Citation:

* - Corresponding Author

References

[1] H. Karbasian, A.E. Tekkaya: J. Mater. Process. Technol, Vol. 210 (2010), p.2103–2118.

Google Scholar

[2] A. Turetta, S. Bruschi and A. Ghiotti: J. Mater. Process. Technol, Vol. 177 (2006), pp.396-400.

Google Scholar

[3] Abdulhay B, Bourouga B, Dessain C, et al: Heat. Transfer. Eng, Vol. 32 (2011), pp.497-505.

Google Scholar

[4] Abdulhay B, Bourouga B and Dessain C: Applied. Thermal. Eng, Vol. 31 (2011), pp.674-685.

Google Scholar

[5] H Hoffmann, H So, H Steinbeiss: CIRP. Ann-Manuf. Techn, Vol. 56 (2007), pp.269-272.

Google Scholar

[6] Liu W, Liu H, Xing Z, et al: A. Turetta, S. Bruschi and A. Ghiotti, Vol. 22 (2012), pp.534-541.

Google Scholar

[7] Shapiro A B: Using LS-Dyna for Hot Stamping (7th European LS-DYNA Conference, Austria 2009).

Google Scholar