Preface
Cutting Process of Rolled Ti-6Al-4V in Drilling of Countersunk Hole
p.3
p.3
Drilling Characteristics of Plastic Materials with Adaptive Control of Feed Rate
p.13
p.13
Multi-Quality Decision Using Preference Selection Index Method in Laser Trepan Cutting of Thin Electrical Steel
p.21
p.21
Influence of Axis Configuration in 5-Axis Control Machining Center on Geometric Error of Cubic Machined Surfaces
p.31
p.31
Electrochemical Machining of Micro Hole under Magnetic Field Assistance
p.39
p.39
Study on Improvement of Machining Accuracy of Corner-R with Square Endmill -Effect of Constant Number of Simultaneous Cutting Edge-
p.47
p.47
Exploring the Impact of 3D Printing Variables on Gear Surface Finish and Wear Behavior
p.59
p.59
Influence of Post Heat Treatment on Slurry Erosion Behavior of Wire Arc Additive Manufactured (WAAMed) Inconel-625
p.65
p.65
Preface
Abstract:
You might also be interested in these eBooks
Info:
Periodical:
Key Engineering Materials (Volume 1010)
Online since:
March 2025
Сopyright:
© 2025 Trans Tech Publications Ltd. All Rights Reserved
Share: