Paper Titles

Development of a Biosensor Based on a Piezoelectric Film
p.491

Microstructure-Based Constitutive Modeling for the Analysis and Design of Aluminium Sheet Forming Processes
p.497

Finite-Element Simulation and Experimental Validation of a Plasticity Model of Texture and Strain-Induced Anisotropy
p.501

Damage-Induced Anisotropy and Deformability of Brittle Rock-Like Materials
p.505

Taylor Analysis for {111}<112> Twinning on One System and {111}<110> Slip Under Tension and Compression Flow Conditions
p.509

Effect of the Substrate Thermal Expansion Coefficient on the Thermal Residual Stresses in W-Si-N Sputtered Films
p.513

On the Compensation Law Observed in Thermally Stimulated Current Experiments
p.517

Strain Hardening Anisotropy of Aluminium Alloys during Complex Loading: Strain Reversal Effects
p.521

Numerical Study of the Influence of Imperfection of the Tip of a Vickers Indenter on Ultramicrohardness Test Results
p.525

HomeKey Engineering MaterialsKey Engineering Materials Vols. 230-232Taylor Analysis for {111}<112> Twinning on One...

Taylor Analysis for {111}<112> Twinning on One System and {111}<110> Slip Under Tension and Compression Flow Conditions

Article Preview

Abstract:

You might also be interested in these eBooks

Advanced Materials Forum I

Info:

Periodical:

Key Engineering Materials (Volumes 230-232)

Pages:

509-512

DOI:

https://doi.org/10.4028/www.scientific.net/KEM.230-232.509

Citation:

Cite this paper

Online since:

October 2002

Authors:

Bruno M. Chaparro, José Valdemar Fernandes

Keywords:

Twinning, Plastic Deformation, Polycrystals, Taylor Model

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2002 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

[1] U.F. Kocks and C.N. Tomé: Texture and Anisotropy - Preferred orientations in polycrystals and their effect on materials properties (Cambridge University Press, 1998)

[2] G.Y. Chin, W.F. Hosford and D.R. Mendorf: Accommodation of constrained deformation in f.c.c. metals by slip and twinning (Proc. Royal Society, 1969)

[3] J.W. Christian and S. Mahajan,: Prog. Mater. Sci., 39 (1995), p.1

[4] G.Y. Chin, W.L. Mammel and M.T. Dolan: Trans. Metall. Soc. AIME, 245 (1969), p.383

[5] E Aernoudt, P. Van Houtte and T. Leffers: Mater. Sci. Tech., 6 (1995), p.88

[6] M. M. Vieira, Plastic deformation of the AISI 304 stainless steel in simples and complex strain paths (MSc Thesis, Technology Group, Mechanical Engineering Department, Coimbra University, 1998)