Influence of Agglomerate Size on the Properties of Al2O3-Al2Cu3 Multiphase Ceramic Coatings

Hai Ping Cui; Jun Yan; Shi Guo Du; Xin Kang Du

doi:10.4028/www.scientific.net/KEM.336-338.1791

Paper Titles

A Comparison of the Surface Properties of DLC and Nanocrystalline Diamond
p.1776

Influence of Impurities on the High-Temperature Water-Vapour Corrosion of Environmental Barrier Rare-Earth Silicates
p.1780

Analysis of Heat Transfer and Thermal Stress in Thermal and Environmental Barrier Coatings
p.1784

Investigation of YSZ Thin Films on Silicon Wafer and NiO/YSZ Deposited by Ion Beam Sputtering Deposition (IBSD)
p.1788

Influence of Agglomerate Size on the Properties of Al₂O₃-Al₂Cu₃ Multiphase Ceramic Coatings
p.1791

Effect of Heat Treatment on Coloration of Ag Doped TiO₂-SiO₂ Films
p.1793

Photo-Hydrophilicity and Photo-Catalysis of TiO₂-SiO₂ Coating on Ceramics
p.1796

AFM Investigation of Nano Particle Incorporated Sb Doped SnO₂ Films
p.1799

Development and Characterization of Nano-TiO₂/HA Composite Bioceramic Coating on Titanium Surface
p.1802

HomeKey Engineering MaterialsKey Engineering Materials Vols. 336-338Influence of Agglomerate Size on the Properties of...

Influence of Agglomerate Size on the Properties of Al₂O₃-Al₂Cu₃ Multiphase Ceramic Coatings

Abstract:

Al2O3-Al2Cu3 multiphase coatings were prepared on the surface of steel by reactive flame spray. The binding strength, microhardness and abrasion quality of the coatings were measured and analyzed. The influence of the agglomerate size on the properties of the coatings was emphatically studied to choose suitable size range for Al-CuO reactive system. The results showed that coatings prepared by using –150∼+250 meshes agglomerates exhibited good mechanical properties.