DEFORM-3D Based on Machining Simulation during Metal Milling

Abstract:

Machining of metals make use of thermal mechanical FEM model. Analysis of nonlinear elastoplastic finite element simulation of milling of 45 # steel material use software of DEFORM-3D that is finite element simulation technology. DEFORM-3D software could be carried out on prediction of the milling force. Through finite element analysis, distribution of stress field, strain field and temperature field of workpiece and tool is obtained under the influence of thermal mechanical. The prediction accuracy of the model was validated experimentally and the obtained numerical and experimental results were found in good agreement.

• Periodical: Key Engineering Materials (Volumes 579-580)
• Pages: 197-201
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.579-580.197
• Online since: September 2013
• Authors: Zhan Li Wang, Yan Juan Hu, Dan Zhu
• Keywords: Cutting Force, Cutting Stress, Cutting Temperature, DEFORM-3D, Milling

References

[1] C.L. Han: Cemented Carbide, VoL. 21 (2004) No. 3, pp.214-217. (In Chinese).

[2] S.C. Li, P. Ken and A.M. Liu: Hydromechatronics Engineering, Vol. 39 (2011) No. 23, p.8. (In Chinese).

[3] D. Lu and J.F. Li: China Mechanical Engineering, VoL. 19 (2008) No. 22, pp.2708-2710. (In Chinese).

[4] Z. T Tang, Z.Q. Liu and X. Ai: China Mechanical Engineering, VoL. 18 (2007) No. 6, pp.746-751. (In Chinese).

[5] J.G. R, W H. A Cook: Proceedings of the Seventh International Symposium on Ballistics (Netherlands, 1983) pp.541-547.

[6] Zorev N N: ASME (New York, USA 1963) pp.42-49.