Finite Element Modal Analysis for Face-Milling Cutter

Abstract:

In this paper, a face-milling tool system is dealt with the Finite Element Modal Analysis (FEMA) using advanced contact technology functionalities. Dynamic characteristics analysis is performed and the stiffness contribution is included in the modal pre-stressed analysis. Natural frequencies and mode shapes of vibration are calculated. The FEMA is followed by experiments performed for different operating conditions of the face-milling system. The dynamic characteristics obtained in this paper can be used to optimize the face-milling cutter in high speed machining.

• Periodical: Key Engineering Materials (Volumes 589-590)
• Pages: 19-22
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.589-590.19
• Online since: October 2013
• Authors: Lu Ning Liu, Zhen Yu Shi, Zhan Qiang Liu
• Keywords: Dynamic Characteristic, Face-Milling Tool, Modal Analysis

References

[1] Ng.E.G. Szable, M. Dumitrescu: CIRP Ann. Manuf. Tech. Vol. 53 (2004), p.69.

[2] Q.L. Cheng, Y.L. Ice and H. Y Dong: J. Zhejiang Univ. Eng. Sci. Vol. 40 (2006), p.113.

[3] J.R. Bakera, K.E. Rouchb: Fin. Elem. Anal. Des. Vol. 38 (2002), p.1029.

[4] W.Y. Lee, K.W. Kim and H.C. Sin: Int. J. Mach. Tool. Manuf. Vol. 42 (2002), p.961.

[5] B.N. Dattay: Mech. Syst. Signal Process. Vol. 16 (2002), p.83.