Fabrication and Characterization of 3-D Photonic Crystals of Various Microspheres by Electrophoretic Self-Assembly

Abstract:

Fabrication of high sphericity, monodispersed microspheres (100~600 nm) of various oxides (SiO₂, TiO₂, ZnO, In₂O₃, SnO₂) via sol-gel process and polystyrene (PS) microspheres (200~400 nm) via emulsion polymerization is presented. A high colloidal stability suspension was obtained by adjusting the zeta potential of such spheres and pH of the colloid. The 3-D photonic crystal (PhC) templates of opaline structure on ITO-coated glasses and silicon wafers were easily formed under electrophoretic self-assembly (EPSA) of microspheres under the influence of exerting electrical forces. Different setups of counter-electrode were attempted to establish an electrical field. The lattice constant of an ordered opal structure by EPSA can also be tuned by the electrical field gradient. Interestingly various self-assembled 3-D structures of silica microspheres in either symmetrical curvilinear profile or triangular ridges can be produced through EPSA route using specific counter-electrode setups. The measured optic properties of such 3-D PhC templates manifest photonic bandgap (PBG) based on planar-wave expansion (PWE) simulation to verify the existence of real PBG in PhC samples with tunable nanostructures. The PS PhC templates are currently used to easily transform into inverse opal structure (IOS) by infiltrating sol of other oxides with high dielectric constant (e.g. ZnO or TiO₂) and filled with metallic nanoparticles (Ni or Cu) by electrochemical deposition or chemical bath deposition (CBD).

• Periodical: Key Engineering Materials (Volume 654)
• Pages: 106-113
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.654.106
• Online since: July 2015
• Authors: Rong Fuh Louh*, Yi Jui Huang, Ya Chih Tsai, Danny Ho, Doris Liao
• Keywords: Colloidal Crystals, Electrophoretic Self-Assembly, In₂O₃ , Inverse Opal Structure, Microspheres, Opal Structure, Photonic Bandgap, Photonic Crystals, Plane Wave Expansion, Polystyrene, SiO₂, SnO₂, TiO₂, ZNO

References

[1] W. Lee, S.A. Pruzinsky, P.V. Braun, Multi-photon polymerization of waveguide structures within three dimensional photonic crystals, Adv. Mater. 14, 271-274 (2002).

DOI: 10.1002/1521-4095(20020219)14:4<271::aid-adma271>3.0.co;2-y

[2] C.K. Ullal, M. Maldovan, E.L. Thomas, G. Chen, Y. -J. Han, S. Yang, Photonic crystals through holographic lithography: Simple cubic, diamond-like, and gyroid-like structures, Appl. Phys. Lett. 84, 5434-5436 (2004).

DOI: 10.1063/1.1765734

[3] M. Deubel, G.V. Freymann, M. Wegener, S. Pereira, K. Busch, C. M. Soukoulis, Direct laser writing of three-dimensional photonic-crystal templates for telecommunications, Nature Mater. 3, 444-447 (2004).

DOI: 10.1038/nmat1155

[4] R.F. Louh and Yi-Jui Eric Huang, Electrophoretic Self-Assembly of Sol-Gel Derived Silica Microspheres, Solid State Phenomena Vol. 124 (2007) 599-602.

DOI: 10.4028/www.scientific.net/ssp.124-126.599

[5] R.M. Amos, J. G. Rarity, P. R. Tapster, T. J. Shepherd, and S. C. Kitson, Fabrication of large-area face-centered-cubic hard-sphere colloidal crystals by shear alignment, Phys. Rev. E 61, 2929-2935 (2000).

DOI: 10.1103/physreve.61.2929

[6] M. Trau, D.A. Saville, and I. A. Aksay, Field-induced layering of colloidal crystals, Science 272, 706-709 (1996).

DOI: 10.1126/science.272.5262.706

[7] M. Holgado, et al., Electrophoretic deposition to control artificial opal growth, Langmuir 15, 4701-4704 (1999).

DOI: 10.1021/la990161k

[8] R.C. Hayward, D.A. Saville, and I. A. Aksay, Electrophoretic assembly of colloidal crystals with optically tunable micropatterns, Nature 404, 56-59 (2000).

DOI: 10.1038/35003530

[9] A.L. Rogach, N.A. Kotov, D.S. Koktysh, J.W. Ostrander, and G.A. Ragoisha, Electrophoretic deposition of latex-based 3D colloidal photonic crystals: A technique for rapid production of high-quality opals, Chem. Mater. 12, 2721-2726 (2000).

DOI: 10.1021/cm000274l