Study on High-Frequency Fatigue Properties of PVD AlTiN Coating of Cutting Tool

Abstract:

Based on ultrasonic vibration-assisted mode, high-frequency impacting tests with diamond indenter at different amplitudes on AlTiN coating of cutting tool are carried out. The microstructure and morphology are obtained by scanning electron microscopy (SEM) and 3D profiler. The failure mechanism of coating under impact is analyzed. The high frequency fatigue property of the coating is analyzed. The results show that: lateral crack could be seen under impact test; the maximum tensile stress occurs close the edge of the contact zone of impact center; AlTiN coating is easy to emerge the fatigue damage under the high-frequency impact loading, and the adhesion strength of the coating and substrate interface affects the impact fatigue strength of cutting tool coating.

• Periodical: Key Engineering Materials (Volume 764)
• Pages: 370-375
• DOI: https://doi.org/10.4028/www.scientific.net/KEM.764.370
• Online since: February 2018
• Authors: Ning Chang Wang*, Qing Feng Liu, Xin Cheng, Feng Jiang
• Keywords: Adhesion Strength, Coating, Fatigue Failure, High Frequency Impact

References

[1] Stoiber M, Panzenböck M, Mitterer C, Surface and Coatings Technology, (142–144) (2001), 117-124.

DOI: 10.1016/s0257-8972(01)01220-8

[2] Vijayakumar K, Apurbba Kr. Sharma, Mayuram M M, Materials Letters, 54 (2002) 403-413.

[3] Zhu M H, Zhou Z R, Kapsa Ph, Wear, 250(1-12) (2001) 650-657.

[4] Zhang X H, Liu D X , Tan H B, Surface and Coatings Technology, 203 (2009) 2315-2321.

[5] Bhatt A, Attia H, Vargas R, Tribology International, 43 (5-6) (2010) 1113-1121.

[6] Lin Y J, Agrawal A, Fang Y, Wear, 264 (2008) 226-234.

[7] Zheng Liyun, Wang Yuguo, Zhao Lixin, Rare metal material and engineering, S1(2008) 752-755.

[8] Liu Mingxing, Contact stress analysis based on FEM for the surface coating fretting fatigue, Hefei, Hefei University of Technology, (2012).

[9] Lou Xiaoling, Bao Yumei, Chai Guozhong, Journal of zhengjang university technology, 05 (2006), 563-566.

[10] Jiang F, Yan L, Rong Y M, Int J Adv Manuf Technol, 64 (2013) 1555-1563.