Study on the Method for the Optimization of Cutting Parameters

Jing Ying Zhang; Si Qin Pang; Qi Xun Yu

doi:10.4028/www.scientific.net/MSF.532-533.325

Paper Titles

Research on the Modeling Algorithm for the Camber of Large-Sized Revolving Parts
p.309

Kinematic Modeling and Error Analysis for a 3DOF Parallel-Link Coordinate Measuring Machine
p.313

A Study on Machining Quality of a Kind of Functional Hollow Lightweight Metallic Micro-Helixes by Bio-Limited Forming
p.317

Dry-Cutting Concrete Study of Diamond Saw Blade with Different Segment Width
p.321

Study on the Method for the Optimization of Cutting Parameters
p.325

Study on the Thermal Properties of Phenolic Resin Mix-Modified by Nano-Alumina
p.329

An Air Texturing Process for Hybridization of Different Reinforcement Filament Yarns by Commingling Process
p.333

Breaking Elongation Properties of Hybrid Yarns by Commingling Process
p.337

Research on High Speed Face Milling Cutter Based on the Model of Stress Field
p.341

HomeMaterials Science ForumMaterials Science Forum Vols. 532-533Study on the Method for the Optimization of...

Study on the Method for the Optimization of Cutting Parameters

Abstract:

This article discusses the problem about the method for the optimization of cutting parameters. A newly developed computational method which is different from the former was used for the optimization of cutting parameters. This method has its advantages of the controllability of the precision and higher speed when the precision requirement of the system is not very high. It can optimize cutting parameters toward the objectives of maximum production rate, minimum production cost and maximum profit rate.