Paper Titles

The Effect of Up-Cutting and Down-Cutting Directions on Materials Swelling in Ultra-Precision Raster Milling
p.697

Numerical Simulation on Thixoforming of Wrought Magnesium Alloy
p.701

Topological Design of Three-Dimensional Microstructure Based on Homogenization Effective Method
p.705

Determination of the Interface Heat Transfer for the Investment Castings of Aerofoil-Shaped Turbine Blades Using Optimization and FE Method
p.709

Efficient Algorithms for Calibration of Cutting Force Coefficients in Flat End Milling
p.713

The Calculation of Two-Phase Gas/Liquid Homogenous Flow in Bearing Chambers
p.717

Thermal Elasto-Plastic Asperity Contacts of Layered Media
p.721

Using Gray Forecasting Estimates Cost of Aviation Project
p.725

Cutter Optimal Selection of CAPP System Facing to the Modern Manufacture
p.729

HomeMaterials Science ForumMaterials Science Forum Vols. 532-533Efficient Algorithms for Calibration of Cutting...

Efficient Algorithms for Calibration of Cutting Force Coefficients in Flat End Milling

Article Preview

Abstract:

You might also be interested in these eBooks

Advances in Materials Manufacturing Science and Technology II

Info:

Periodical:

Materials Science Forum (Volumes 532-533)

Pages:

713-716

DOI:

https://doi.org/10.4028/www.scientific.net/MSF.532-533.713

Citation:

Cite this paper

Online since:

December 2006

Authors:

Min Wan, Wei Hong Zhang, Gang Tan, Guo Hua Qin

Keywords:

Cutting Force Model, Flat End Milling, Instantaneous Uncut Chip Thickness

Export:

RIS, BibTeX

Price:

Permissions CCC:

Request Permissions

Permissions PLS:

Request Permissions

Сopyright:

© 2006 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation: