Effect of Molybdenum on Hot Deformation and Processing Maps of Austenitic Stainless Steels

Ming Jia Wang; Shan Shan Long; Song Mei Mu; Yan Wang; Lei Chen

doi:10.4028/www.scientific.net/MSF.575-578.1076

Paper Titles

Research on Creep Constitutive Model of TC11 Titanium Alloy Based on RBFNN
p.1050

Hot Ductility of Fe-18Cr-12Mn-0.55N High Nitrogen Austenitic Stainless Steel
p.1056

Simulation of Intercritical Austenization of a C-Mn Cold Rolled Dual Phase Steel
p.1062

Research on Heat Treatment Techniques and Structure Properties of CuNi₂TiCrZr Alloy
p.1070

Effect of Molybdenum on Hot Deformation and Processing Maps of Austenitic Stainless Steels
p.1076

Physical Simulation of Dynamic Recrystallization Behavior of 7050 Aluminum Alloy
p.1083

Study on Preparation of Ti Powder by Self-Propagating High-Temperature Synthesis (SHS) with Magnesiothermit Reductive Process
p.1086

Effect of Zinc Content on the Ageing Behavior of Al-Zn-Mg-Cu-Li Alloys
p.1093

Effects of Gas Multicomponent Thermochemical Treatment Process on Structure and Properties of Steel 20
p.1097

HomeMaterials Science ForumMaterials Science Forum Vols. 575-578Effect of Molybdenum on Hot Deformation and...

Effect of Molybdenum on Hot Deformation and Processing Maps of Austenitic Stainless Steels

Abstract:

In this paper, hot compression tests were carried out using a Gleeble-3500 simulator to establish the law of hot deformation and recrystallization behavior, and to generate the corresponding processing maps. The influence of Mo was also investigated by comparing the results of hot deformation in such steel. The addition of molybdenum to stainless steel slightly increases the hot deformation stress and recrystallization temperature, while reduces the efficiency of power dissipation η.