p.723
p.727
p.731
p.735
p.741
p.745
p.749
p.753
p.757
Preparation and Properties Fluoralkylpolysiloxane Modified Polyurethane Films
Abstract:
Fluoralkylpolysiloxane modified Polyurethane (FSPU) films with high water contact angle (CA) were prepared. fluoralkylpolysiloxane was obtained using perfluoro octyl sulfuryl fluoride and terminal amino-silicone oil as reactants. Then, the isocyanate end capped PU prepolymer was synthesized by reacting isocyanate with a soft segment mixed by active amino-end-capping fluoralkylpolysiloxane and polyether glycol. The fluoralkylpolysiloxane modified PU films were obtained after the PU prepolymer was cured by 3,3 '- dichloro -4,4' – amino - diphenyl methane (MOCA). The results showed that the modified polyurethane with 10% (mass fraction) PFATPS had a good compatibility, low surface energy, surface water contact angle and surface oil contact angle was improved by 49° and 37° respectively, and heat resistance, water resistance was apparently improved.
Info:
Periodical:
Pages:
741-744
Citation:
Online since:
April 2009
Authors:
Price:
Сopyright:
© 2009 Trans Tech Publications Ltd. All Rights Reserved
Share:
Citation: