Modeling of the Influence of Admixing and Prealloying on the Optimisation of Compressibility and Sinter-Hardenability of Steel Powders

Abstract:

The automotive industry applies pressure on the PM industry to produce components with superior mechanical properties at minimum cost. In this regard, sinter-hardenable powders are particularly well suited since they allow direct quenching of components at the end of the sintering cycle, thus eliminating the extra steps required for heat treating. This paper presents the results of the modeling of the influence of admixing and/or prealloying on the optimization of compressibility and hardenability of sinter-hardenable steel powders. A first design of experiments (DOE) was used to optimize the chemical composition and to study the interactions between prealloyed elements (Nickel, Chromium, Molybdenum and Manganese) and admixed elements (Nickel, Chromium, Manganese and Copper) on hardenability and compressibility. A second DOE was generated based on the results obtained in the first series. Results show that among all of the examined alloying elements, only prealloyed nickel, chromium and molybdenum had a significant effect on compressibility and hardenability. Moreover, within the range of concentrations under study, the optimum sinter-hardenable powder had the following (prealloyed) chemistry: 1.5 wt-% Ni, 0.55 wt-% Cr and 1.25 wt-% Mo.

• Periodical: Materials Science Forum (Volumes 706-709)
• Pages: 2107-2111
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.706-709.2107
• Online since: January 2012
• Authors: Nicolas Giguère, Carl Blais
• Keywords: Compressibility, Hardenability, Powder metallurgy, Steel

References

[1] R.M. German, Powder Metallurgy & Particulate Materials Processing, 1994, Metal Powder Industries Federation, Princeton.

[2] M. Paullin, «State of the North American PM Industry – 2008», Advances in Powder Metallurgy & Particulate Materials, compiled by R. Lawcock, A. Lawley and P.J. McGeehan, Metal Powder Industries Federation, NJ, (2008).

[3] G.F. Bocchini, B. Rivolta, G. Silva, E. Poggio, M.R. Pinasco, M.G. Ienco, «Microstructural and Mechanical Characterisation of Some Sinter Hardening Alloys and Comparisons with Heat Treated PM Steels», Powder Metallurgy, vol. 47, No. 4, 2004 pp.343-351.

DOI: 10.1179/003258904x14464

[4] N. Giguère, C. Blais, Optimization of Compressibility and Hardenability by Admixing and Prealloying, International Journal of Powder Metallurgy, Volume 46, Issue 1, 2010, pp.17-29.