Cutting Properties of Austenitic Stainless Steel by Using Linear Polarized CO₂ Laser without Assist Gas

Abstract:

Recently, laser cutting is used in many industries. Generally, in laser cutting of metallic materials, assist gas and its nozzle are needed to remove the molten metal. However, because of the gas nozzle should be moved closer to the position about 1 mm from the surface of a workpiece, it is thought that existence of the nozzle causes lack of flexibility of laser cutting. Therefore, the new cutting process, Assist Gas Free laser cutting (hereafter, called as AGF laser cutting), has been developed and investigated about cutting properties in our laboratory. In this process, the pressure at the bottom side of a workpiece is reduced by a vacuum pump, and the molten metal can be removed by the air flow caused by the pressure difference between both sides of the specimen. On the other hand, when cutting of metallic materials with a linear polarized laser is performed, it is known that the cutting kerf might slant. This phenomenon is also observed in AGF laser cutting. In the present study, cutting properties of austenitic stainless steel by using liner polarized CO₂ laser in AGF laser cutting was investigated. Cutting speed and direction were varied in order to study the effect of these parameters on cutting properties. As a result, when the angle formed by the cutting direction and the polarized direction of laser was parallel, the kerf slant could be depressed, and the critical cutting speed could be the fastest in any other cutting direction.

• Periodical: Materials Science Forum (Volumes 706-709)
• Pages: 2228-2233
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.706-709.2228
• Online since: January 2012
• Authors: Hitoshi Ozaki, Takahito Mima, Hiroshi Kawakami, Jippei Suzuki
• Keywords: Assist Gas Free, CO₂ Laser, Laser Cutting, Linear Polarization, Stainless Steel (SS)

References

[1] T. Arai, M. Kutsuna, I. Miyamoto: Laser Cutting Process, Machinist Publishing, (1994), pp.1-2.

[2] J. Suzuki: Japanese Patent Publication No. 2007-190590 (2007).

[3] M. F. Zaeh, J. Moesl, J. Musiol, F. Oefele: Material Processing with Remote Technology – Revolution or Evolution?, Physics Procedia, Vol. 5 (2010), p.19–33.

DOI: 10.1016/j.phpro.2010.08.119

[4] J. Hatwig, G. Reinhart, M. F. Zaeh: Automated Task Planning for Industrial Robots and Laser Scanners for Remote Laser Beam Welding and Cutting, Production Engineering, Vol. 4, No. 4 (2010), p.327–332.

DOI: 10.1007/s11740-010-0252-3

[5] H. Shamoto, T. Ikeda, A. Tsuboi: Development of Remote Cutting Technology by High Quality Solid State Laser, Reports on The 406th Topical Meeting of The Laser Society of Japan, (2010), p.17–21.

[6] T. Arai, I. Miyamoto: Basics of Laser Processing (I), Machinist Publishing, (1993), pp.35-36.

[7] M. Kanaoka: Effect of the Beam Polarization Characteristics on Accuracy in Laser Cutting, Transactions of the Japan Society of Mechanical Engineers, Series C, Vol. 57, No. 544 (1991), p.3997–4001.

DOI: 10.1299/kikaic.57.3997

[8] F. O. Olsen: Cutting with Polarized Laser Beams, DVS-Berichte, Vol. 63 (1980), p.197–200.