Using the Flat-End Mill in the Strip Width Machining

Can  Zhao; Yun Fei Guan; Yan Yan Guo

doi:10.4028/www.scientific.net/MSF.723.170

Paper Titles

Predicting Range of Chip Breaking of 3D Complex Groove Turning Inserts with Neural Networks
p.148

Tool Path Planning of 5-Axis Finishing Milling Machining for Closed Blisk
p.153

The Experimental Modal Analysis of High Speed Machining Tool System Based on Integral Polynomial Recognition Method
p.159

Drilling Simulation of High Manganese Steel Processing Based on the J-C Constitutive Relation
p.164

Using the Flat-End Mill in the Strip Width Machining
p.170

Experiment Study of Tool Wear and Surface Integrity in High Speed Milling of a New Damage-Tolerant Titanium Alloy
p.177

Influence of Tool Flank Wear on Surface Integrity in Orthogonal Milling of Powder Metallurgy Superalloy
p.182

Investigation into Roughness of Surface Polished by Abrasive Waterjet with Taguchi Method and Dimensional Analysis
p.188

The Optimization of Cutting Parameters for Surface Roughness in High Speed Milling Based on Taguchi Method
p.196

HomeMaterials Science ForumMaterials Science Forum Vol. 723Using the Flat-End Mill in the Strip Width...

Using the Flat-End Mill in the Strip Width Machining

Abstract:

Surface machining has become a difficult problem in aviation manufacturing, we always using ball-end mills, it is easy to determine the tool position in five-axis machining, but because of the large program, low material remove rate, the processing cycle long, and the surface accuracy is also poor. The paper suggests using the flat-end mill to strip width machining. Using this way, the CNC program is shorter, surface quality is better, the most import is reducing the machining time obviously. Now this method only used in the simple surface, so it requires further research.