The Optimization of Cutting Parameters for Surface Roughness in High Speed Milling Based on Taguchi Method

Peng Nan Li; Ming Chen; Xiao Jian Kang; Li Na Zhang; Ming Zhou

doi:10.4028/www.scientific.net/MSF.723.196

Paper Titles

Using the Flat-End Mill in the Strip Width Machining
p.170

Experiment Study of Tool Wear and Surface Integrity in High Speed Milling of a New Damage-Tolerant Titanium Alloy
p.177

Influence of Tool Flank Wear on Surface Integrity in Orthogonal Milling of Powder Metallurgy Superalloy
p.182

Investigation into Roughness of Surface Polished by Abrasive Waterjet with Taguchi Method and Dimensional Analysis
p.188

The Optimization of Cutting Parameters for Surface Roughness in High Speed Milling Based on Taguchi Method
p.196

A Practical Study on the Surface Integrity of High-Speed Cylindrical Grinding of SiC
p.202

Influence of Milling Parameters on Surface Residual Stresses of 7050-T7451 Aluminum Alloy
p.208

Study on Surface Roughness in Ultrasonic High-Speed Milling of SiCp/Al Composites
p.214

Influence of Material Flow Stress on Surface Roughness in High-Speed Machining
p.219

HomeMaterials Science ForumMaterials Science Forum Vol. 723The Optimization of Cutting Parameters for Surface...

The Optimization of Cutting Parameters for Surface Roughness in High Speed Milling Based on Taguchi Method

Abstract:

In this study AISI 1045 steel of different hardness are used in high speed milling. According to Taguchi method, cutting parameters (milling speed, milling depth, feed per tooth) and workpiece hardness for the influence of high speed milling of the surface roughness are optimized. Through this study, not only the optimal cutting parameters of the minimum surface roughness is obtained, but also the main cutting parameters that effect performance in high speed milling is analysed. Researching results can be provided to guide establishment of the high speed milling process.