Study on Surface Roughness in Ultrasonic High-Speed Milling of SiCp/Al Composites

Dao Hui Xiang; Guang Xi Yue; Hai Tao Liu; Bo Zhao

doi:10.4028/www.scientific.net/MSF.723.214

Paper Titles

Investigation into Roughness of Surface Polished by Abrasive Waterjet with Taguchi Method and Dimensional Analysis
p.188

The Optimization of Cutting Parameters for Surface Roughness in High Speed Milling Based on Taguchi Method
p.196

A Practical Study on the Surface Integrity of High-Speed Cylindrical Grinding of SiC
p.202

Influence of Milling Parameters on Surface Residual Stresses of 7050-T7451 Aluminum Alloy
p.208

Study on Surface Roughness in Ultrasonic High-Speed Milling of SiCp/Al Composites
p.214

Influence of Material Flow Stress on Surface Roughness in High-Speed Machining
p.219

An Integrated Approach to the Design and Analysis of an Ultra-High Speed Air-Bearing Spindle
p.227

Effect of (Ni,Mo) and (W,Ti)C on the Microstructure and Mechanical Properties of TiB₂ Ceramic Tool Materials
p.233

A Computer-Based Intelligent System for Automatic Tool Selection
p.238

HomeMaterials Science ForumMaterials Science Forum Vol. 723Study on Surface Roughness in Ultrasonic...

Study on Surface Roughness in Ultrasonic High-Speed Milling of SiCp/Al Composites

Abstract:

The orthogonal analysis and single factor analysis were used to analyze the roughness of SiCp/Al metal matrix composites (SiCp/Al MMCs) with ultrasonic high-speed milling and high-speed milling. The influences of milling speed, feed and milling depth on the roughness were studied. The research indicates that the roughness in ultrasonic high-speed milling is lower than that in high-speed milling under the same condition, at the same time the optimal parameters of ultrasonic high-speed milling are obtained, this has a guiding significance for finish machining of SiCp/Al composites.