Investigation of Cutting Force in High Feed Milling of Ti6Al4V

Abstract:

Titanium alloys are widely used in aviation and aerospace industry due to their special mechanical properties. In the process of machining titanium alloys, cutting force is an important physical quantity. In this paper, a series of experiments were carried out to investigate the cutting force in detail during high feed milling of titanium alloy Ti6Al4V with different high feed cutters. Effects of cutting parameters, such as milling speed, feed per tooth, radial cutting depth and axial cutting depth on cutting force were analyzed. The results showed that cutting force presented an obvious increasing trend with the increase of feed per tooth and axial cutting depth. However, the effects of cutting speed and radial cutting depth on cutting force were not obvious.

• Periodical: Materials Science Forum (Volume 770)
• Pages: 106-109
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.770.106
• Online since: October 2013
• Authors: Jie Xu, Bin Rong, Hong Zhou Zhang, Dong Sheng Wang, Liang Li
• Keywords: Cutting Force, High Feed Cutter, High Feed Milling, Titanium Alloy

References

[1] K.A. Venugopal, S. Paul and A.B. Chattopadhyay: Wear Vol. 262(2007), p.1071.

[2] Peng Liu, Jiu-hua XU, Yu-can FU: J Zhejiang Univ Sci A(Appl Phys ＆ Eng) Vol. 12 (2011), p.56.

[3] Qi Shi, Liang Li, Ning He, Wei Zhao and Xiaoli Liu: Int J Adv Manuf Technol Vol. 64 (2013), p.49.

[4] E.O. Ezugwu, J. Bonney, Y. Yamane: Journal of Materials Processing Technology Vol. 134(2003), p.233.

[5] Information on http: /www. imould. com.

[6] Information on http: /www. secotools. com.