Research on Machinability of SF6 in Diamond Cutting with Cutting Fluid

Peng Jia

doi:10.4028/www.scientific.net/MSF.770.234

Paper Titles

Numerical Simulation of Milling Process: A Total Procedure
p.217

Numerical Simulation on Stress Distribution and Failure of Composites Holes with Cold Expansion
p.221

The Wear of Al₂O₃-Based Ceramic Cutting Tool in High-Speed Face Milling of AISI H13 Steel
p.226

Research on Critical Cut Depth of Glass BK7 in Diamond Cutting
p.230

Research on Machinability of SF6 in Diamond Cutting with Cutting Fluid
p.234

Research on Micromechanical Drilling of Micro-Hole Array in PVC Mask
p.239

Research on the Influence of Different Surface Machining States on the Inclination of the Porous Gas Bearing
p.244

Research on the Modeling and Experimenting of Burr Formation Process in Double-Edged Micro-Plat End Milling Operation
p.248

Optimization of the Two-DOF Passive Damper for the Machining Vibration Control Based on the SDM
p.253

HomeMaterials Science ForumMaterials Science Forum Vol. 770Research on Machinability of SF6 in Diamond...

Research on Machinability of SF6 in Diamond Cutting with Cutting Fluid

Abstract:

For the technology of diamond cutting of optical glass, the machinability of glass is poor, which hindering the practical application of this technology. In order to investigate and ameliorate the machinability of glass, and achieve optical parts with the satisfied surface quality and dimensional accuracy, this paper first conducted SF6 indentation experiment by Vickers microhardness instrument, and then the scratching tests with increasing depths of cut were conducted on glass SF6 to evaluate the influence of the cutting fluid properties on the machinability of glass. Based on this, turning tests were carried out, and the surface quality of SF6 was assessed based on the detections of the machined surfaces roughness. Experimental results indicated that compared with the process of dry cutting, the machinability of glass SF6 can be improved by using the cutting fluid.