Research on Micromechanical Drilling of Micro-Hole Array in PVC Mask

Wen Kai Fu; Ning He; Liang Li; Meng Zhao; Rong Bian

doi:10.4028/www.scientific.net/MSF.770.239

Paper Titles

Numerical Simulation on Stress Distribution and Failure of Composites Holes with Cold Expansion
p.221

The Wear of Al₂O₃-Based Ceramic Cutting Tool in High-Speed Face Milling of AISI H13 Steel
p.226

Research on Critical Cut Depth of Glass BK7 in Diamond Cutting
p.230

Research on Machinability of SF6 in Diamond Cutting with Cutting Fluid
p.234

Research on Micromechanical Drilling of Micro-Hole Array in PVC Mask
p.239

Research on the Influence of Different Surface Machining States on the Inclination of the Porous Gas Bearing
p.244

Research on the Modeling and Experimenting of Burr Formation Process in Double-Edged Micro-Plat End Milling Operation
p.248

Optimization of the Two-DOF Passive Damper for the Machining Vibration Control Based on the SDM
p.253

Numerical Simulation on the Jet Characteristics of Abrasive Jet
p.257

HomeMaterials Science ForumMaterials Science Forum Vol. 770Research on Micromechanical Drilling of Micro-Hole...

Research on Micromechanical Drilling of Micro-Hole Array in PVC Mask

Abstract:

Globalization of the micro manufacturing technology has become a trend. This technology has been widely used in many fields, especially in aerospace field and biological medicine. The electrolytic PVC mask of micro-hole array is difficult to machine because of the high positional accuracy of the micro-hole array, small diameter of the holes and the high requirement of machining quality. This paper studied the influence of workpiece property, optimization of machining parameters, and chips removing in machining of the electrolytic PVC mask using micromechanical drilling. A feasible method with high efficiency is presented.