Residual Strain of OFC Using Synchrotron Radiation

Mutsumi Sano; Sunao Takahashi; Atsuo Watanabe; Ayumi Shiro; Takahisa Shobu

doi:10.4028/www.scientific.net/MSF.777.255

Paper Titles

Evaluation of the Residual Stress in the Cold Spray Technique Using Smooth Particle Hydrodynamics Modelling and Neutron Diffraction
p.205

A Neutron Diffraction Investigation of Residual Stresses in Rail Ends after Severe Deformation of Rail Surfaces
p.213

Strain Analysis in Geological Materials Using Neutron Diffraction and AE Signal Measurement at J-PARC/BL19 "TAKUMI"
p.219

Comparison of Synchrotron Radiation Diffraction and Micromagnetic Stress Analysis in Straightened Steel Pipes
p.225

Synchrotron Diffraction Studies on the Transformation Strain in a High Strength Quenched and Tempered Structural Steel
p.231

Measurement of Residual Stresses in Aluminothermic Rail Welds Using Neutron Diffraction Technique
p.237

Stress Distribution in Iron Powder during Die Compaction
p.243

Residual Stresses Distribution Measured by Neutron Diffraction in Fabricated Square High Strength Steel Tubes
p.249

Residual Strain of OFC Using Synchrotron Radiation
p.255

HomeMaterials Science ForumMaterials Science Forum Vol. 777Residual Strain of OFC Using Synchrotron Radiation

Residual Strain of OFC Using Synchrotron Radiation

Abstract:

Residual strain in oxygen-free copper, one of the materials used in high-heat-load components at SPring-8 front end, was investigated. A strain scanning method with oscillation was employed for strain measurement. The results were compared with those obtained using an elasto-plastic creep FEM analysis.