Effect of Rolling on Mechanical Properties and Fatigue Behavior of an Al-Mg-Sc-Zr Alloy

Article Preview

Abstract:

An aluminum alloy with a chemical composition of Al–6%Mg–0.35%Mn–0.2%Sc–0.08%Zr–0.07%Cr (in wt.) was rolled up to different reductions of 75, 88 and 95% at 360oC and at ambient temperature. The static mechanical properties and the high-cyclic fatigue (HCF) life were examined. It was shown that the hot rolling results in increased yield stress (YS) and ultimate tensile strength (UTS). However, ductility and fatigue limit of the hot rolled alloy and initial as-cast ingot are nearly the same. The combination of hot and cold rolling leads to significant improvement of tensile strength and fatigue resistance, while ductility tends to reduce with increasing the rolling reduction. The cold rolled alloy exhibits the endurance limit under fatigue conditions, while the alloy in the both as-cast and hot rolled conditions exhibits only fatigue strength. The effect of the deformation structure on the mechanical properties is discussed.

You might also be interested in these eBooks

Info:

Periodical:

Materials Science Forum (Volumes 794-796)

Pages:

331-336

Citation:

Online since:

June 2014

Export:

Price:

Permissions CCC:

Permissions PLS:

Сopyright:

© 2014 Trans Tech Publications Ltd. All Rights Reserved

Share:

Citation:

* - Corresponding Author

[1] I.J. Polmear, Light Alloys. From traditional alloys to nanocrystals. 4th ed., Butterworth-Heinemann/Elsevier, UK, (2006).

DOI: 10.1017/s000192400008670x

Google Scholar

[2] W. F. Hosford. Mechanical Behavior of Materials. Cambridge University Press, New York, 2005, p.279.

Google Scholar

[3] ASM Handbook, vol. 19, Fracture and Fatigue, ASM, Materials Park, OH, (1996).

Google Scholar

[4] J. Røyset, N. Ryum, Inter. Mater. Rev. 50 (2005) 19-44.

Google Scholar

[5] Yu.A. Filatov, V.I. Yelagin, V.V. Zakharov, Mater. Sci. Eng. A 280 (2000) 97.

Google Scholar

[6] R. Kaibyshev, A. Mogucheva, A. Dubyna, Mater. Sci. For. 706-709 (2012) 55-60.

Google Scholar

[7] D. Zhemchuzhnikova, A. Mogucheva, R. Kaibyshev. Mater. Sci. Eng. A 528 (2013) 132–141.

Google Scholar

[8] R. Kaibyshev, K. Shipilova, F. Musin, Y. Motohashi, Mater. Sci. Eng. A 396 (2005) 341–351.

Google Scholar

[9] P.J. Hurley, F.J. Humphreys, Acta Mater. 51 (2003) 1087–1102.

Google Scholar

[10] Q. Liu, D. Juul Jensen, N. Hansen. Acta Mater. 46 (1998) 5819–5838.

Google Scholar

[11] H. Halim, D.S. Wilkinson, M. Niewczas, Acta Mater. 55 (2007) 4151–4160.

Google Scholar

[12] A. Vinogradov, A. Washikita, K. Kitagawa, V.I. Kopylov, Mater. Sci. Eng. A 349 (2003) 318-326.

Google Scholar

[13] Y. Estrin, A. Vinogradov, Intern. Journal of Fatigue 32 (2010) 898–907.

Google Scholar

[14] P. Cavaliere. Intern. Journal of Fatigue 31 (2009) 1476–1489.

Google Scholar