Evaluation of Mechanical Properties of the Rocket Thrust Chamber Material under Flight Conditions

Abstract:

Thrust chamber of rocket engines often operate under conditions of rapid heating environments with temperatures approaching the melting points of the materials involved. Therefore, for the optimum design of rocket engines, it is necessary to obtain the properties of thrust chamber materials under actual operating conditions. The heating rates and loading rates in conventional (laboratory) tensile stress-strain tests, which are intended to evaluate the high temperature tensile properties of the materials, are usually very low compared to that actually encountered in rocket engines. The heating rates in conventional stress-strain tests are of the order of 0.4K per second to 0.5K per second only, whereas the combustion and aerodynamic heating rates in rockets and re-entry vehicles will usually exceed 100K per second. In this context, a very important beginning has been made to experimentally determine the high temperature tensile properties of KC20WN (a cobalt based superalloy) used in earth storable liquid rocket engine thrust chamber under conditions of rapid rates of heating which actually exists during flight. These investigations have shown that the elevated temperature strength of KC20WN depends upon the heating rate (or heating time) and can be considerably higher for rapid-heating conditions than for conventional heating conditions.

• Periodical: Materials Science Forum (Volumes 830-831)
• Pages: 219-222
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.830-831.219
• Online since: September 2015
• Authors: C.R. Anoop, John Bejoy, Thomas Tharian, P.V. Venkitakrishnan
• Keywords: Gleeble, KC20WN Alloy, Mechanical Properties, Rapid Heat Testing

References

[1] ASTM E151 -64 (Re approved 1981)- Standard Practice for Tension Tests of Metallic Materials at elevated temperatures with rapid heating and conventional or rapid strain rates.

DOI: 10.1520/e0151

[2] Alloy Data Sheet , Haynes Inc USA.

[3] Dieter George E , Mechanical Metallurgy, Mc-GrawHill Inc, (1986).