Composites Based on Thermoset Resin and Orbignya phalerata (Babassu Coconut): Evaluation of Mechanical Properties, Morphology and Water Sorption

Abstract:

Researches in plant fiber composites have been developed with greater frequency during the last years, especially on environmental issues. The opening of the market, especially in the automotive sector, points to the replacement of synthetic additives by natural reinforcements. Characteristics such as low density and abrasiveness, superior mechanical properties and low cost are the most sought in these composites. The aim of this study was to evaluate the behavior of composites based polyester matrix and fiber of the babassu coconut epicarp, at levels of 5, 7.5 and 10% under testing of tensile strength and impact, as well as the morphology by microscopy scanning electron and water absorption. All composites were prepared raw fibers and fiber with treated with alkaline solution of 5% NaOH. As regards the mechanical properties, an increasing of the rigidity of the system was observed, and the kinetics of water absorption increased levels indicated for compounds with high content of fibrous reinforcement. By SEM there was greater interaction between fiber and matrix.

• Periodical: Materials Science Forum (Volume 869)
• Pages: 237-242
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.869.237
• Online since: August 2016
• Authors: Carlos Alberto Lopes Fonteles, Gustavo Figueiredo Brito, Laura Hecker Carvalho, Tatianny Soares Alves, Renata Barbosa
• Keywords: Babassu Coconut, Mechanical Properties, Polimeric Composites, Water Sorption

References

[1] E.C. Ramires, J.D. Megiatto Jr, C. Gardrat, A. Castellan: Bioresource Techonology Vol. 101 (2010), p. (1998).

[2] F.L., Matthews, R.D. Rawlings: Composite Materials: Engineering and Science. (Chapman & Hall, London, 1999).

[3] D. Rouison, M. Couturier, M. Sain, B. Macmillan, B.J. Balcon: Polym. Composites Vol. 26 (2005), p.510.

[4] M.A. Iozzi, G.S. Martins, M.A. Martins, F.C. Ferreira, A.E. Job, L.H.C. Mattoso: Polímeros: Ciência e Tecnologia Vol. 20 (2010), p.25.

[5] ASTM D3039/D3039M – 08: Standard Test Method for Tensile Properties of Polymer Matrix Composite Materials.

[6] ASTM D256 – 10: Standard Test Method for Determining the Izod Pendulum Impact Resistance of Plastics.

[7] ASTM D570 – 98 (10): Standard Teste Method for Water Absorption of Plastics.

[8] S.C. Amico, C.C. Angrizani, M.L. Drummond: Journal of Reinforced Plastics and Composites Vol. 29 (2010), p.179.

[9] D.B. Dittenber, H.V.S. Gangarao: Compos. Appl. Sci. Manuf. Vol 43 (2012), p.1419.

[10] Z.N. Azwa, B.F. Yousif , A.C. Manalo, W. Karunasena: Materials and Design Vol. 47 (2013), p.424.