Study on the Influence of Anisotropy on Cutting Performance of Aviation Aluminium Alloy 7050-T7451

Abstract:

Based on the hypocycloid theory, a highspeed orthogonal cutting simulation model was established. The cutting parameters (cutting speed, feed rate) and plane forming angle of the workpiece of aeronautical aluminium alloy 7050-T7451 pre-stretched rolled sheet were simulated and validated. The mapping relationship between cutting parameters, anisotropy and cutting performance was analyzed. The results show that the degree of anisotropy and the difficulty of material cutting are proportional to the forming angle, and the anisotropy decreases with the increase of cutting speed and the decrease of feed speed. Finally, the optimal cutting process range of aluminum alloy 7050-T7451 was obtained, which provides data support for highspeed cutting of anisotropic materials.

• Periodical: Materials Science Forum (Volume 990)
• Pages: 29-35
• DOI: https://doi.org/10.4028/www.scientific.net/MSF.990.29
• Online since: May 2020
• Authors: Hui Wang, Ying Meng, Duo Duo Li, Xiu Li Fu*, Qi Hang Shi
• Keywords: Aeronautical Aluminum Alloy 7050-T7451, Anisotropy, Machinability

References

[1] X. Li and R. Jiang: China Basic Sci Vol.17 (2015), pp.11-20.

[2] W. Ren, J. Wang, and F. Cong : Light Alloy Fabrication Technol Vol.47 (2019), pp.9-19.

[3] X. Xu , W. Jia, P. Huang, D. Du, and C. Zhang: Heat Treat Met Vol.43 (2018), pp.57-61.

[4] L. Lian, R. Jiang, H. Wu: J Mech Strength Vol.40 (2018), pp.943-947.

[5] D. Iliescu, D. Gehin and I. Iordanoff: Compos Sci Technol Vol.70 (2010), pp.73-80.

[6] X. Cai, K. Qiu and C. Wang: J Nanjing Univ Aeronaut Astronaut Vol.46 (2014), pp.684-693.

[7] J.Pang, J. Zhao, A. Li and J. Zang: Mach Des Manu (2018), pp.159-161.

[8] Y. Ding and C. Liu: Aeronaut Manuf Technol Vol.62 (2019), pp.68-73.

[9] Y. Meng, X. Fu, Y. Pan and N. Xu : J Mech Eng Vol.54 (2018), pp.78-85.

[10] Z.An, X. Fu, Y. Pan and Q. Du: Technol Test (2015), pp.101-105.