Dynamic Characteristics of the Sinter-Forged Cu-Cr Alloys with the Variation of Chrome Content

Abstract:

This paper is concerned with the dynamic characteristics of sinter-forged Cu–Cr alloy for various strain-rates. The amount of the chrome content is varied from 10 %wt to 30 %wt in order to investigate the influence of the chrome content on the dynamic characteristics. The dynamic response at the corresponding level of strain-rate should be obtained with an adequate experimental technique and corresponding apparatus due to the inertia effect and the stress wave propagation. In this paper, the high speed tensile testing machine is utilized in order to identify the dynamic response of the Cu–Cr alloy at the intermediate strain-rates and the split Hopkinson pressure bar is used at the high strain-rates. Experimental results from both the quasi-static and the high strain-rates up to the 5000/s are interpolated with respect to the amount of the chrome content in order to construct the Johnson–Cook and the modified Johnson–Cook model as the constitutive relation for numerical simulation of the dynamic impact behavior of electrodes.

• Periodical: Solid State Phenomena (Volumes 116-117)
• Pages: 255-258
• DOI: https://doi.org/10.4028/www.scientific.net/SSP.116-117.255
• Online since: October 2006
• Authors: Jung Han Song, Hoon Huh
• Keywords: Dynamic Material Property, High Speed Material Testing Machine, Sinter-Forged Cu-Cr Alloy, Split Hopkinson Pressure Bar (SHPB)

References

[1] H. Huh, J.H. Lim, S.B. Kim, S.S. Han and S.H. Park: Key Eng. Mater. Vol. 274-276 (2004), p.403.

[2] M.A. Meyers: Dynamic Behavior of Materials (John Wiley & Sons, New York 1994).

[3] H. Kolsky: Stress Wave in Solids (Dover, New York 1949).

[4] G.R. Johnson and W.H. Cook: Eng. Fract. Mech. Vol. 21 (1985), p.31.

[5] W.J. Kang, S.S. Cho, H. Huh and D.T. Chung: Int. J. Vehicle Des. Vol. 21 (1999), p.424.