Fabrication of Rheological Material with Rotational Pressure Type Equipment

P.K. Seo; Dae Up Kim; C.G. Kang

doi:10.4028/www.scientific.net/SSP.116-117.271

Paper Titles

Dynamic Characteristics of the Sinter-Forged Cu-Cr Alloys with the Variation of Chrome Content
p.255

Dynamic Tensile Tests of Auto-Body Steel Sheets with the Variation of Temperature
p.259

Pressure-Composition-Isotherm Behavior of Partially Remelted Magnesium Alloys
p.263

Research on Thixoforging Magazine Plate of AZ91D Magnesium Alloy in Semi-Solid State
p.267

Fabrication of Rheological Material with Rotational Pressure Type Equipment
p.271

Microstructural Evolution of Semi-Solid AZ61 Magnesium Alloy during Reheating Process
p.275

Study on Partial Remelting Microstructures and Mechanical Properties of ZK60-RE Magnesium Alloy
p.279

Semi-Solid Forming of Al-Mg-Zn Based High Strength Alloys
p.284

Microstructure and Mechanical Properties of Cast and Semi-Solid Formed Mg-Al-Zn Alloys
p.288

HomeSolid State PhenomenaSolid State Phenomena Vols. 116-117Fabrication of Rheological Material with...

Fabrication of Rheological Material with Rotational Pressure Type Equipment

Abstract:

Many rheocasting processes had been proposed because of the difficulty of recycling, the limit of material, and the high cost of raw material in thixocasting. But, these rheocasting processes also had disadvantages such as the high initial investment cost and the lower mechanical properties than thixocasting. In this study, a continuous fabrication of rheological material with pressure rotation equipment was newly devised to overcome the disadvantages of rheocasting process. In order to investigate the thixoformability, reheating experiments were carried out with the material fabricated by the newly devised equipment.