Dependency of the Quality of the Active Vibration Damping on the Sensor and Actuator Location – Simulation and Experiment

Jana Kovářová; Miloš Schlegel; Jan Dupal

doi:10.4028/www.scientific.net/SSP.147-149.215

Paper Titles

Comparison the Accuracy of the Extrapolation Methods of the Time Phase Coincidence in Synchronization of Power Generating Units
p.191

Control Efficiency Analysis of Linear Oscillating Mechatronic Device
p.197

Controller Design for a Rubbing Rotor
p.203

Dependency of the Quality of the Active Vibration Damping on the Sensor and Actuator Location – Simulation and Experiment
p.215

Dependent versus Independent Variable Formulation for the Dynamics and Control of Cranes
p.221

Flight Simulator as a Tool for Flight Control System Synthesis and Handling Qualities Research
p.231

Fuzzy Logic Controller for Position Actuator SMA
p.237

Human-Robot Interaction Controller Based on CMOS Stereo Vision and FPGA Chip
p.243

HomeSolid State PhenomenaSolid State Phenomena Vols. 147-149Dependency of the Quality of the Active Vibration...

Dependency of the Quality of the Active Vibration Damping on the Sensor and Actuator Location – Simulation and Experiment

Abstract:

The paper deals with the vibration suppressing of cantilever beam. The state feedback control law is used, where the controller and observer are designed by pole assignment method. First two natural frequencies are considered for design of the control law. The analysis of the location of actuator and sensor are investigated. Experimental results obtained from the closed loop system with incomplete pole assignment are compared with uncontrolled system.