Synthesis of Silanated Coconut Oil-Based Waterborne Polyurethane Coating for Corrosion Protection

Abstract:

In this study, an eco-friendly coconut oil-based polyol blend was synthesized for bio-based waterborne polyurethane (WBPU) and WBPU-silane composite coatings. It was demonstrated that an increase in silane content incorporated into the WBPU matrix significantly enhanced the corrosion protection of WBPU coatings. Results also show a fourfold increase in the adhesion strength of WBPU-silane composite coatings as compared to that of bare WBPU coatings. Further, the water contact angle revealed that hydrophobic properties increase as the silane content incorporated into the WBPU matrix increases. This work provides a novel route for enhanced corrosion protection utilizing a bio-based polyol blend.

• Periodical: Solid State Phenomena (Volume 351)
• Pages: 77-87
• DOI: https://doi.org/10.4028/p-49uIMX
• Online since: October 2023
• Authors: Dave Joseph E. Estrada*, Amierson С. Tilendo, Arnold C. Alguno, Alona A. Lubguban, Gerard G. Dumancas, Anthony O. Maputi, Vanessa Enobio, Roberto M. Malaluan, Arnold A. Lubguban
• Keywords: Adhesion Strength, Anti-Corossion Coating, Coconut Oil, Silane, Thermal Stability, Waterborne

References

[1] Y. Zhu, C. Romain, and C. K. Williams, "Sustainable polymers from renewable resources," Nature, vol. 540, no. 7633, p.354–362, 2016.

DOI: 10.1038/nature21001

[2] S. Ji, W. Cao, Y. Yu, and H. Xu, "Visible-Light-Induced Self-Healing Diselenide-Containing Polyurethane Elastomer," Adv. Mater., vol. 27, no. 47, p.7740–7745, 2015.

DOI: 10.1002/adma.201503661

[3] M. Salzano de Luna, "Recent Trends in Waterborne and Bio-Based Polyurethane Coatings for Corrosion Protection," Adv. Mater. Interfaces, vol. 2101775, 2022.

DOI: 10.1002/admi.202101775

[4] H. Deng, S. Kang, C. Wang, H. He, and C. Zhang, Palladium supported on low-surface-area fiber-based materials for catalytic oxidation of volatile organic compounds, vol. 348. 2018.

DOI: 10.1016/j.cej.2018.04.184

[5] A. Llevot and M. Meier, "Perspective: green polyurethane synthesis for coating applications," Polym. Int., vol. 68, no. 5, p.826–831, 2019.

DOI: 10.1002/pi.5655

[6] C. C. Santos, M. C. Delpech, and F. M. B. Coutinho, "Thermal and mechanical profile of cast films from waterborne polyurethanes based on polyether block copolymers," J. Mater. Sci., vol. 44, no. 5, p.1317–1323, 2009.

DOI: 10.1007/s10853-009-3272-7

[7] S. Kang et al., "Design and Synthesis of Waterborne Polyurethanes," vol. 1706237, p.1–7, 2018.

DOI: 10.1002/adma.201706237

[8] Y. Han, J. Hu, and Z. Xin, "In-situ incorporation of alkyl-grafted silica into waterborne polyurethane with high solid content for enhanced physical properties of coatings," Polymers (Basel)., vol. 10, no. 5, 2018.

DOI: 10.3390/polym10050514

[9] N. Sukhawipat, N. Saetung, J. F. Pilard, S. Bistac, and A. Saetung, "Synthesis and characterization of novel natural rubber based cationic waterborne polyurethane: Effect of emulsifier and diol class chain extender," J. Appl. Polym. Sci., vol. 135, no. 3, p.17–19, 2018.

DOI: 10.1002/app.45715

[10] M. M. Rahman, M. H. Zahir, M. B. Haq, D. A. Al Shehri, and A. M. Kumar, "Corrosion inhibition properties of waterborne polyurethane/cerium nitrate coatings on mild steel," Coatings, vol. 8, no. 1, 2018.

DOI: 10.3390/coatings8010034

[11] T. Kattiyaboot and C. Thongpin, "Effect of Natural Oil Based Polyols on the Properties of Flexible Polyurethane Foams Blown by Distilled Water," Energy Procedia, vol. 89, p.177–185, 2016.

DOI: 10.1016/j.egypro.2016.05.024

[12] C. Zhang, T. F. Garrison, S. A. Madbouly, and M. R. Kessler, Recent advances in vegetable oil-based polymers and their composites, vol. 71, no. 2017. Elsevier B.V., 2017.

DOI: 10.1016/j.progpolymsci.2016.12.009

[13] P. M. Paraskar, M. S. Prabhudesai, V. M. Hatkar, and R. D. Kulkarni, "Vegetable oil based polyurethane coatings – A sustainable approach: A review," Prog. Org. Coatings, vol. 156, no. April, 2021.

DOI: 10.1016/j.porgcoat.2021.106267

[14] H. Liang et al., "Bio-based cationic waterborne polyurethanes dispersions prepared from different vegetable oils," Ind. Crops Prod., vol. 122, no. March, p.448–455, 2018.

DOI: 10.1016/j.indcrop.2018.06.006

[15] Y. Zhang et al., "Waterborne polyurethanes from castor oil-based polyols for next generation of environmentally-friendly hair-styling agents," Prog. Org. Coatings, vol. 142, no. November 2019, p.105588, 2020.

DOI: 10.1016/j.porgcoat.2020.105588

[16] S. S. Panda, B. P. Panda, S. K. Nayak, and S. Mohanty, "A Review on Waterborne Thermosetting Polyurethane Coatings Based on Castor Oil: Synthesis, Characterization, and Application," Polym. - Plast. Technol. Eng., vol. 57, no. 6, p.500–522, 2018.

DOI: 10.1080/03602559.2016.1275681

[17] V. V. Gite, R. D. Kulkarni, D. G. Hundiwale, and U. R. Kapadi, "Synthesis and characterisation of Polyurethane coatings based on trimer of isophorone diisocyanate (IPDI) and monoglycerides of oils," Surf. Coatings Int. Part B Coatings Trans., vol. 89, no. 2, p.117–122, 2006.

DOI: 10.1007/BF02699641

[18] V. Mishra, J. Desai, and K. I. Patel, "Industrial Crops & Products ( UV / Oxidative ) dual curing polyurethane dispersion from cardanol based polyol : Synthesis and characterization," Ind. Crop. Prod., vol. 111, no. March 2017, p.165–178, 2018.

DOI: 10.1016/j.indcrop.2017.10.015

[19] F. Carré, "1. Introduction," L'archéologie en Haute-Normandie, Bilan des connaissances, p.7–12, 2018.

DOI: 10.4000/books.purh.5104

[20] M. Kumar and R. Kaur, "Effect of Different Formulations of MDI on Rigid Polyurethane Foams based on Castor Oil," vol. 2, no. May, p.29–42, 2013.

[21] Y. J. Zhu and F. Chen, "Microwave-assisted preparation of inorganic nanostructures in liquid phase," Chem. Rev., vol. 114, no. 12, p.6462–6555, 2014.

DOI: 10.1021/cr400366s

[22] "Coconut production worldwide from 2000 to 2020." .

[23] B. S. Ampon, J. J. C. Budiongan, J. D. Mangubat, and B. A. N. Semense, "Optimum Functionalization of Coconut Oil-Based Polyester Polyol (CPP) via Polycondensation with Phthalic Anhydride," Mindanao State University - Iligan Institute of Technology, 2019.

[24] D. Zhu and W. J. van Ooij, "Corrosion protection of AA 2024-T3 by bis-[3-(triethoxysilyl) propyl]tetrasulfide in neutral sodium chloride solution. Part 1: Corrosion of AA 2024-T3," Corros. Sci., vol. 45, no. 10, p.2163–2175, 2003.

DOI: 10.1016/S0010-938X(03)00060-X

[25] N. Asadi, R. Naderi, M. Saremi, S. Y. Arman, M. Fedel, and F. Deflorian, "Study of corrosion protection of mild steel by eco-friendly silane sol-gel coating," J. Sol-Gel Sci. Technol., vol. 70, no. 3, p.329–338, 2014.

DOI: 10.1007/s10971-014-3286-8

[26] S. R. Kunst, G. A. Ludwig, H. R. P. Cardoso, J. A. Santana, V. H. V. Sarmento, and C. De Fraga Malfatti, "Hybrid films with (trimethoxysilylpropyl) methacrylate (TMSM), poly (methyl methacrylate) PMMA and tetraethoxysilane (TEOS) applied on tinplate," Mater. Res., vol. 17, p.75–81, 2014.

DOI: 10.1590/S1516-14392014005000069

[27] L. Nuraini, E. Triwulandari, M. Ghozali, M. Hanafi, and J. Jumina, "Synthesis of polyurethane/silica modified epoxy polymer based on 1,3-propanediol for coating application," Indones. J. Chem., vol. 17, no. 3, p.477–484, 2017.

DOI: 10.22146/ijc.22321

[28] H. Asemani, F. Zareanshahraki, and V. Mannari, "Design of hybrid nonisocyanate polyurethane coatings for advanced ambient temperature curing applications," J. Appl. Polym. Sci., vol. 136, no. 13, p.0–1, 2019.

DOI: 10.1002/app.47266

[29] "Standard Test Methods for Measuring Adhesion by Tape Test 1," p.1–8, 2012.

[30] "Standard Test Method for Tension Testing of Calcium Phosphate and Metallic Coatings," ASTM Stand., vol. 05, no. Reapproved 2011, p.1–6, 2013.

[31] J. D. Yesselman, S. Horowitz, C. L. Brooks, and R. C. Trievel, "Frequent side chain methyl carbon-oxygen hydrogen bonding in proteins revealed by computational and stereochemical analysis of neutron structures," Proteins Struct. Funct. Bioinforma., vol. 83, no. 3, p.403–410, 2015.

DOI: 10.1002/prot.24724

[32] Y. Ma, M. Zhang, W. Du, S. Sun, B. Zhao, and Y. Cheng, "Preparation and Properties of Hydrophobic Polyurethane Based on Silane Modification," 2023.

DOI: 10.3390/polym15071759

[33] K. Pacaphol and D. Aht-Ong, "The influences of silanes on interfacial adhesion and surface properties of nanocellulose film coating on glass and aluminum substrates," Surf. Coatings Technol., vol. 320, p.70–81, Jun. 2017.

DOI: 10.1016/J.SURFCOAT.2017.01.111

[34] S. H. Tilford, B. Arkles, and J. Goff, "Cyclic Azasilanes and Cyclic Thiasilanes," no. December, p.68103, 2017, [Online]. Available: www.gelest.com.

[35] C. Kumudinie, "Polymer–Ceramic Nanocomposites: Interfacial Bonding Agents," Encycl. Mater. Sci. Technol., p.7574–7577, 2001.

DOI: 10.1016/b0-08-043152-6/01356-5