Search results

From the flooding results, dissolution of CO2 into oil leads to recovery increase because of crude oil viscosity reduction.
Hence, it is necessary to reduce carbon emission and CO2 capture and storage is prospective for emission reduction and enhancing oil recovery with CO2.
The results showed that after outlet closed, most of asphaltene deposited from the oil and the deposited amounts were 2.51wt% and 3.31wt% respectively, and the deposited asphaltene ratios were up to 93.66% and 94.03%, which were similar to the data obtained from static tests.

The results obtained by ICP-OES showed a rapid reduction in silicon (Si) and sodium (Na), and noted an accelerator increase in calcium (Ca) and phosphorus (P) ion concentrations in BG (M)-PVA that the BG (M)-PVA-20Cip.
Data are presented as means ± standard deviation (S.D.).Statistical significance was assessed by the Fisher’s test, P < 0.05 was considered statistically significant.
In fact, the Si concentration BG(M)-PVA was reduced very quickly after 15 days of implantation, but this reduction is less advanced for BG(M)-PVA-20Cip.

Ni-P/AZ-X catalysts were prepared by temperature-programmed reduction.
However, the reduction extent is not pronounced due to the effect of Ni-P component.
Vol. 168 (1997), p. 421 [9] JCPDS Powder Diffraction File, International Centre for Diffraction Data, Swarthmore, PA, 2002

The monitoring data showed that displacement of lower part was bigger than that of upper, and the sliding because of the reservoir water level decline.
Finally, using the monitoring data from 2007 to 2012, this paper elucidate the landslide deformation phase and study the deformation mechanism and failure mode.
Analysis of Monitoring Data.
As for the landslide, it originated due to long-term progressive shear strength reduction of tectonically weakened rock mass and the rainfall acted in this case as a trigger of a process.

This means that after a registration and calibration, actual positions of patient and surgical tools are interpreted as spatial data in relation to the plan data.
The plan data in our experimental study is represented by the preoparative planner.
Results of the analysis between the predefined path and the sensor data are sent to the embeded fuzzy con- troller.
The input data to the fuzzy controller is the position error and the rate of change of the position error.
With discrete time data, the area of the curve was approximated with the following formula [20]: (1) where e (k) is the error at time k and the area between two data points is approximated to a trapezium.

The experimental system consists of true triaxial machine, hydraulic control and data acquisition equipments.
At first, the images were transformed into the black and white bitmaps by the software Photoshop, and then were transferred to the binary images and binary data matrices with Matlab.
Then it had a sharp reduction.
After rockburst the cracks coalesced finally so the fractal dimension again had a reduction.
After rockburst the cracks coalesced finally so the fractal dimension had a reduction again.

The Deltatherm system is used to capture a thermal image of the specimen (known as DC data) simultaneously with the thermoelastic data (known as AC data).
Comparison of thermal data - thermocouple interrogation and calibrated data.
Plot comparison of baseline thermoelastic data and corrected data.
Thermoelastic data from composite panel in fatigue rig
The initial data shows a discontinuity at the defect.

In the paper monotonic, cyclic and fatigue data for En295 steel were presented.
The elongation to failure and reduction in area were A5 =28,9 % and Z=32 % respectively.
It can been observed better agreement between experimental data and predictions based on Golos-Ellyin hypothesis.
The detailed monotonic, cyclic and fatigue data for En295 steel were presented.
In the case of three-step loading, smaller differences of ∑ni/Nfi =1 from experimental data were observed.

The Database Management Software Oracle is used to store and manage related spatial data
The 1:5000 scaled DEM in the year 2002 is used as historical data and GPS-RTK measured plane and elevation coordinate are applied to produce 2012 terrain data in which the spatial interpolation algorithm in ArcGIS data interpolation model is used. 3.
The remote sensing dynamic monitoring for the channel occupied areas 3.1 Data preprocessing and data analysis Monitoring of channel occupied area and calculation of the volume of channel occupied area in the study reservoir area is based on analysis and calculation of high resolution terrain data, multi-temporal high-resolution remote sensing images and GPS measurement data of the reservoir area.
(6) Coordinate System: Beijing 54 coordinate systems are used in all the spatial data
It includes image enhancement, image filtering, image reduction, image mosaic, geometric correction and radiometric correction.

However, the accuracy of multi-parameter evaluation method depends upon the information content provided by the initial data; therefore, the pre-processing of data in decision-making and method itself are still worth in-depth study and improvement.
In this sense, data normalization is necessary before clustering.
The technique of data normalization applied by this paper is showed as follows: Data normalization for efficiency-type indexes (large value-oriented): Data normalization for cost-type indexes (small value-oriented): To avoid that element equal to 0, we introduce the balance factor, which is usually valued 0.9.
The decision matrix is transformed into fuzzy matrixafter data normalization
However, the accuracy of multi-parameter evaluation depends upon the information content provided by the initial data; therefore, the pre-processing of data in decision-making and method itself are still worth in-depth study and improvement.